Ultimate Support Deltex Pro Series User manual

Rotate
Tilt
Visit ultimatesupport.com
to download a detailed
product manual, read full
warranty details and to
register for warranty.
800.525.5628 . www.ultimatesupport.com . Copyright 2018, Ultimate Support Systems . All Rights Reserved
ADJUSTING ULTI-BOOM PRO
To adjust tilt, pan, rotate, extend, & retract, simply turn
the large center knob counter clock-wise. The length of
the boom can be adjusted by the patented StableLock lever.
The Ulti-Boom Pro, item #17651, is available from
Ultimate Support Resellers everywhere. Learn more
at http://ultimatesupport.com.
Patented
StableLock
Lever.
Extend & Retract
Pan
ULTI-BOOM PRO INSTRUCTIONS
(Optional Accessory, NOT INCLUDED!)
DELTEX®PRO SERIES
KEYBOARD STANDS
Manual

DELTEX PRO SERIES SETUP DELTEX PRO SERIES SETUP
Swing out rear leg to fully extended position.
LEG SETUP ARM SETUP
Rear Leg
Thumb Screws
Arms
T-Connector Slides into the Rear Leg
Fully Open Rear Leg
Tribar Arm
Leg Assembly
Tribar Arm
Insert T-connector on side legs into the inside of rear leg, being
sure that the threaded holes are on top. Push side legs fully
into bottom bracket so that the holes in the bracket line up with
the threaded holes in the side leg assembly.
Insert thumb screws through bottom bracket and into side legs.
Tighten thumbscrews.
Position clamp on column face and install bracket and T-screw,
placing tapered edge of bracket into groove on column face.
Tighten T-screw fully. To adjust, loosen T-screw and slide clamp
to desired position.
Attach Tribars to clamp by inserting Tribar Hook. Push Tribar
down into clamp receiver.
Side leg assembly and Tribar arms store in tote bag for
easy storage.
Clamp
Clamp