Ultimate Support SP-100 User manual

SATELLITE POLES
Manual
Visit ultimatesupport.com
to download a detailed
product manual, read full
warranty details and to
register for warranty.
800.525.5628 . www.ultimatesupport.com . Copyright 2017, Ultimate Support Systems . All Rights Reserved
SP-100 SP-90 SP-80
SP-100 HEIGHT ADJUSTMENT
Handle
Handle
Using Air-Powered Lift Assist
Put speaker on stand. Firmly grip handle, loosen
z-knob and guide telescoping tube to desired height.
Tighten z-knob. CAUTION: For light speakers, grip
handle tightly while loosening z-knob.
To lower speaker, firmly grip handle, loosen z-knob
and guide telescoping tube down. Lighter speakers
will take more effort to lower. Tighten z-knob.
Loosen
Z-Knob
to Release
Tighten
Z-Knob
to Hold
This stand carries a gas powered shock that
pushes up when z-knob is loosened. Keep clear of
telescoping tubing and make sure z-knob is fully
tightened. For best results when lowering stand,
keep speaker on stand.
Caution!
Lift speakers
weighing
35-45 lbs.
with ease!

SP-90 HEIGHT ADJUSTMENT
Using TeleLock®
Turn the gray dial to the lock, rise, or lower position to
adjust stand height. The locked position holds speaker in
place. The rise position allows the speaker to rise, but NOT
lower.
To lower speaker, slowly turn gray dial to the lower position.
The faster you turn it to the lower position the faster the
speaker will fall. For added support, use hand to control
speed of speaker lowering.
AT TACHING TO SUBW00FER
Seating Your Speaker Pole
Place pole into subwoofer and while pushing down firmly
turn clock-wise until tightened (Do not over tighten). To
remove pole, turn counter clock-wise until it stops turning,
then lift pole out.
Fully Seating Your Speaker Pole
Place speaker on pole, with the weight of the speaker
pushing down, loosen slightly, then fully retighten speaker
pole. Once the pole is fully seated, adjust speaker to
desired height.
Using the 20mm Threads
Remove the small screw on the side of the universal fit
adapter, use a 2mm allen wrench. Pull off the bottom of
the universal fit adapter. Remove the center screw, then
unscrew top of universal fit adapter. Screw pole into
desired subwoofer.
Center Screw
M5 Socket
Head Screw
Uses 4mm
Allen Wrench
Top of
Universal
Fit Adapter
Bottom of
Universal
Fit Adapter
Speaker Placed
on Pole
Small Screw
M3 Button
Head Screw
Uses 2mm
Allen Wrench