Ultimate Support V-Stand Series User manual

LIMITED LIFETIME WARRANTY
Go to ultimatesupport.com for More Details
Manual
V-STAND
SERIES
KEYBOARD
STAND
Visit ultimatesupport.com
to download a detailed
product manual, read full
warranty details and to
register for warranty.
800.525.5628 . www.ultimatesupport.com . Copyright 2015, Ultimate Support Systems . All Rights Reserved
SPECIAL INSTRUCTIONS
• For safety’s sake, be sure to adjust V-Stand® Pro
height ONLY when keyboard is not on stand.
• Make sure height settings match on both inner struts
before placing keyboard on V-Stand® Pro!
•Use pins to look stand arms and legs inplace. This
makes it easy to move the stand around.
•The V-Stand Pro has a second tier available for
purchase.

SETUP
REDUCING THE WIDTH OF
THE COLUMN STRUTS
HEIGHT ADJUSTMENT
Lay stand on floor in folded
position.
Loosen and remove the screw and
angle adapter from vertical struts.
Separate both legs outward until
they stop.
Flip and turn the angle adapter.
Screw angle adapter back into the
vertical struts.
Secure both legs in an open position
with locking pins.
Repeat steps 1 and 2 to the other side.
Pull vertical struts upward to a
vertical position and spread them
to their open position.
Move support arms into their
horizontal position by swinging them
up and over the vertical struts.
Secure both arms in a horizontal
position with locking pins.
Step 1
Step 1
Step 4
Step 5 Step 6
Step 2
Step 2
Step 3
Step 3
Pull, or rotate, locking pin collar out
to release inner strut.
Raise or lower inner strut to desired
height and push, or rotate, locking
pin collar into locking position.
Step 1 Step 2