Ultimate Support Genesis Series User manual

ADJUSTING GS-10 PRO
To adjust position of hanger arm,
loosen dial on bottom of plate.
GS-10 Pro hanger arm is depth
adjustable (be sure to tighten
dial before hanging guitar).
GS-10 Pro is angle adjustable
(be sure to tighten dial before
hanging guitar).
Visit ultimatesupport.com
to download a detailed
product manual, read full
warranty details and to
register for warranty.
800.525.5628 . www.ultimatesupport.com . Copyright 2018, Ultimate Support Systems . All Rights Reserved
GENESIS®SERIES
GUITAR HANGER
Manual

STEP 1
Place the GS-10 Pro wall mount on wall
at your desired location. For maximum
safety for your guitar, please make sure
mount is level (bubble level pictured
above for illustration).
STEP 2
Using either a pencil or one of the
screws provided, mark the walls
where holes will be drilled.
Level
(4) Plastic Anchor
(# 6 x 1-1/4 in.)
Slat Wall
Slat Wall
3/16"Drill Bit
STEP 1
Making sure the lip is in the lower slat, place
GS-10 Pro slat wall mount on slat wall.
STEP 3
Using a 3/16"drill bit, drill
holes for anchors.
STEP 4
Place #6 x 1-1/4 in. plastic anchors
in holes. If needed, lightly tap in
anchors with hammer.
STEP 5
Line up holes on wall with holes
in mount. Secure with Phillips
head screwdriver /drill gun.
STEP 2
Line upper lip of GS-10 Pro hanger with upper
slot of mount. Push flush with wall, making sure
the two mount shelves line up in hanger slots.
(NOTE: Same instructions for 3"or 4"slats.)
STEP 6
Line upper lip of GS-10 Pro hanger with upper
slot of mount. Push flush with wall, making sure
the two mount shelves line up in hanger slots.
MOUNTING TO DRYWALL
MOUNTING TO SLAT WALL
For 4"Slats
For 3"Slats
Mounting
Shelves
Mounting
Shelves
Hanger
Slots
Hanger
Slots