Unfinished Furniture of Wilmington T-4068A User manual

ITEM NO : T-4068A AND T-4068B
ISSUED DEC 10, 2014
Printed in Vietnam
- 1 - THIS ITEM IS PACKED IN 2 CARTONS
ASSEMBLY INSTRUCTIONS
Description
Item No.
: 40X68 TRESTLE TABLE
: T-4068A AND T-4068B

ITEM NO : T-4068A AND T-4068B
ISSUED DEC 10, 2014
Printed in Vietnam
- 2 - THIS ITEM IS PACKED IN 2 CARTONS
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the finish of your
table. Protect the surface of the table with cloth if you are using any product with rubber feet or base.
PART LIST T-
4
068 A
When unpacking, please carefully not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Top 1
B Cross bar 1
PART LIST T-
4
068 B
When unpacking, please carefully not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following parts:
NO Description Qty Sketch NO Description Qty Sketch
C Base 2

ITEM NO : T-4068A AND T-4068B
ISSUED DEC 10, 2014
Printed in Vietnam
- 3 - THIS ITEM IS PACKED IN 2 CARTONS
HARDWARE LIST
When unpacking, please carefully not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1 Short bolt
( M8x40mm) 12
2 Long bolt
(M8x70mm) 2
3 Lock Washer
(8.5x13mm) 12 4 Flat Washer (8.5x19mm) 12
5 U – Washer
M8 2
6 Allen Key
(K4x80mm) 1
NOTE: HARDWARE IS PACKED IN CARTON T-4068B
STEP 1
Attach cross bar (B) to the bases (C) with bolts (2) and U-washers (5), as shown below. Tighten with
Allen key (6).

ITEM NO : T-4068A AND T-4068B
ISSUED DEC 10, 2014
Printed in Vietnam
- 4 - THIS ITEM IS PACKED IN 2 CARTONS
STEP 2
Attach the Top (A) to the unit (from Step 1) with bolts (1) and washers (2) and (3), as shown below.
Tighten with Allen key (6).