Unfinished Furniture of Wilmington OF-52 User manual

ITEM NO : OF-52
REVISED MAR 01, 2016
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: FILE CABINET
: OF-52

ITEM NO : OF-52
REVISED MAR 01, 2016
Printed in Vietnam
- 2 -
Thank you for purchasing this quality product. This product has been designed for easy assem bly
and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to
beginning assembly, however, make sure all parts and hardware are included and free of obvious
defect. If a part is missing or defective, please contact the store where purchased. If hardware is
missing, or you need help with assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the
parts from being scratched.
-Remove all wrapping material, including staples & packing straps before you start to
assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the
finish of your table. Protect the surface of the table with cloth if you are using any product
with rubber feet or base.
BEFORE ASSEMBLY
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO : OF-52
REVISED MAR 01, 2016
Printed in Vietnam
- 3 -
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO
Description
Qty
Sketch
A
FILE CABINET
1
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Wooden Knob
(30x30mm)
2
2
Pan head screw
*Metal knob: (M4x22mm)
*Wooden knob: (M4x25mm)
2
3
Iron bar
(6x361mm)
4
4
Short screw
(M3 x 15mm)
2
5
Long screw
(M4x30mm)
1
6
Steel band
1
7
Warning label
2
METAL KNOB
(30 x 30mm)
GOES WITH
FINISHED ITEM
ONLY.
PART LIST
HARDWARE LIST

ITEM NO : OF-52
REVISED MAR 01, 2016
Printed in Vietnam
- 4 -
Attach Knobs (1) to front of drawers with pan head screws (2). Tighten with a screwdriver.
Insert iron bars (3) into groove (a) or (b) of the drawer as shown below.
Stick the Warning labels (7) inside all drawers before use.
Attach the Steel band (6) to the unit with Short screws (4) and attach the Steel band to the wall with
the long screws (5) as shown below. Tighten with a screwdriver (to secure the product and prevent
tipping).
STEP 1