Unicol PFT1 User manual

WARNING
Please carefully inspect the product before assembling. If you notice any apparent damage, call your
carrier claims agent and do not continue the installation until it has been reviewed. Please watch for
pinch points. Do not put your fingers between moveable parts. Do not tamper with or disassemble any
spring loaded parts. Before installing, make sure that the supporting surface will support five times the
combined load of the solution and the hardware. Never exceed the maximum load capacity. Please also
layout all components to ensure that you have all of the required parts before proceeding (see BOM list
on following page). Use of this product for anything other than its specified use may result in failure or
personal injury. This product is intended for indoor use only. We recommend using a qualified trades
person for installation. Use an assistant or lifting equipment to lift and position products.
For support, please call: [phone] or email: [email protected]
Revised 08/07/21
01865 767676
[email protected]
www.unicol.com
*Please check model specific details before installing*
PFT1 / PFT3 / PFT4 / PFT21
Screen Size: 40-100” Guide Max. Weight: 60kg

01865 767676
[email protected]
www.unicol.com
2Revised 08/07/21
COMPONENTS
INSTALLERS REQUIRED
1-2
# DESCRIPTION QTY
1Mast 1
2Screen Mount Back Plate 1
3Screen Mount Arms 2
4Base 1
5 Alternative Mount Back Plate & Arms -
6 Alternative Mast Example -
#TOOLS REQUIRED
1 17mm Spanner
2 5mm Allen Key
3 Pozidrive Screwdriver
123
4
56

01865 767676
[email protected]
www.unicol.com
3
Revised 08/07/21
STEP 1
With the mast laying flat on a table (as shown
above) pick up the base (with the help of another
person if necessary) and offer the base to the mast.
Ensure fixing holes are aligned and then secure
with the 4 dome head allen screws provided.
STEP 2
Line the back plate up with the mast, choosing the
best slots for height positioning. Fix 4 hex head
screws from behind the mount adapter and into
the 4 rivet nuts located on the back plate. Ensure
back plate is secure and screws are tightened.
STEP 3
Locate the mounting holes on the back of your
screen. Line the two mounting arms up and using
the tag locks and manufacturer recommended
screws (in fixings pack), attach the arms to the
back of the screen.
STEP 4
Line the screen and arms up with the secured back
plate and offer it up at a slight angle - allowing the
top of the arms to hook over the lip of the back
plate.

4
01865 767676
[email protected]
www.unicol.com
Revised 08/07/21
STEP 5
Gently lower the screen until the arms are securely
hanging on top of the back plate. Once centered,
adjust the level of the screen with the two top
screws on the mount arms. Once leveled secure
the screen by tightening the bottom two screws.