Unicol PLX1 User manual

WARNING
Please carefully inspect the product before assembling. If you notice any apparent damage, call your
carrier claims agent and do not continue the installation until it has been reviewed. Please watch for
pinch points. Do not put your fingers between moveable parts. Do not tamper with or disassemble any
spring loaded parts. Before installing, make sure that the supporting surface will support five times the
combined load of the solution and the hardware. Never exceed the maximum load capacity. Please also
layout all components to ensure that you have all of the required parts before proceeding (see BOM list
on following page). Use of this product for anything other than its specified use may result in failure or
personal injury. This product is intended for indoor use only. We recommend using a qualified trades
person for installation. Use an assistant or lifting equipment to lift and position products.
For support, please call: [phone] or email: [email protected]
Revised 15/12/20
01865 767676
[email protected]
www.unicol.com
*Please check model specific details before installing*
PLX1 / PLX3 / PPX1
PLW1 / PLW3 / PPW1 / PPW3
Screen Size: 33-110” Guide Max. Weight: 80-150kg

01865 767676
[email protected]
www.unicol.com
2Revised 15/12/20
COMPONENTS
INSTALLERS REQUIRED
1-2
# DESCRIPTION QTY
1Dedicated Mount Arms 2
2Dedicated Back Plate 1
3M8 x 25 Cross Head Screws 4
4 Optional 15mm Diameter Spacers -
5 PLW Dedicated Tilting Mount Arms -
6 Alternative Dedicated Mount Arm Styles -
#TOOLS REQUIRED
1 Pozi Head Screwdriver
2 17mm Spanner (when fixing to trolley)
3 3/16th Allen Key
1 2
6
5

01865 767676
[email protected]
www.unicol.com
3
Revised 15/12/20
STEP 1
Using the 4 - 8 wall mounting slots cut out on the
back plate, determine where you want to install
your mount, mark it and fix into position.
Please consider cabling and wall fixings prior to
installation. Please check surface is capable of
supporting 5x the combined solutions weight.
STEP 2
Utilising the fixing pack provided with your mount,
attach the arms to the back of your screen.
Ensure the arms are the correct way up before
tightening.
STEP 3
Using another team member, lift the screen up and
gradually offer it up to the back plate. Gently tilt the
screen forward and hook the arms over the screws
that are protruding out from the sides of the back
plate. Lower the screen until it is securely in place.
STEP 4
Once securely positioned, tighten the side screws
to secure to the mount.
ALT: If using tilting arms, this is when you can
adjust them to suit.
WALL FIXING

4
01865 767676
[email protected]
www.unicol.com
Revised 15/12/20
STEP 1
Line the back plate up with the mount adapter,
as shown above. Fix 4 screws from behind the
mount adapter and into the 4 rivet nuts located on
the back plate. Ensure back plate is secure and
screws are tightened.
STEP 2
Utilising the fixing pack provided with your mount,
attach the arms to the back of your screen.
Ensure the arms are the correct way up before
tightening.
STEP 3
Using another team member, lift the screen up and
gradually offer it up to the back plate. Gently tilt the
screen forward and hook the arms over the screws
that are protruding out from the sides of the back
plate. Lower the screen until it is securely in place.
STEP 4
Once securely positioned, tighten the side screws
to secure to the mount.
ALT: If using tilting arms, this is when you can
adjust them to suit.
STAND / TROLLEY