Uniden BP-100 User manual

1
BP-100
Accessory Battery Pack
For more exciting new products please visit our website:
Australia: www.uniden.com.au
New Zealand: www.uniden.co.nz

2
◆ If any items are missing or damaged, contact your place of purchase
immediately. Never use damaged products!
◆ Need help? Get answers at our website:
www.uniden.com.au for Australian model
www.uniden.co.nz for New Zealand model.
◆ Do not expose the device to flames or dispose of it in a fire: the battery
may explode.
◆ Do not disassemble, modify, or attempt to repair any component of this
product.
◆ This unit is NOT waterproof. DO NOT expose this unit to rain or
moisture.
◆ Use only the batteries indicated in this manual.
What’s in the Box?
◆ 2 Rechargeable Battery (BT-694)
◆ Battery Box
Install Battery
1. Remove the battery from any protective packaging and discard the
packaging accordingly. To remove the cover of the battery box, press in
on the notch and slide the cover down and off.
2. Line up the battery connector with the jack inside the battery box; the
connector only fits one way.
3. Push the connector in until it clicks into place; tug gently on the wires to
make sure the battery is securely connected.
4. Replace the cover and slide it into place.
IMPORTANT SAFETY INSTRUCTIONS
GETTING STARTED
#You can install up to 3 battery packs.

3
Connect AC Adaptor to base
1. Use the AC Adaptor of a compatible base to connect the power jack on
the Battery Box to a regular indoor power outlet.
2. Use the power cable to connect to the DC IN port of a compatible base.
Test the Connection
Pick the handset (of a compatible unit) and press the relevant button (to
start a call - eg, HOME/FLASH). If you don’t hear a dial tone, check the
connection between the base and the Battery box.
Power LED
LED What it indicates
OFF No AC adaptor, No charged battery.
ON AC adaptor powered, one or more battery is charging, or
powered.
With AC Adaptor
Without AC Adaptor (During a Black Out)
Pick the handset (of a compatible unit) and press the relevant button (to
start a call - eg, HOME/FLASH). If you don’t hear a dial tone, check the
connection between the base and the Battery box.
#Battery box will charge under this condition.
#Charge completely (about 24 hours) before using.
The BP-100 battery box is connected in-line between the base and AC
adaptor of a compatible telephone.

4
Battery Information
Parts Number Type Capacity
BT-694 NiMH 650mAh, 2.4V DC
Model AC Adaptor
Type
Input Voltage Output
Voltage
SSE 35 Series AAD-041S(M)
100-240V AC,
50-60Hz
9V, 350 m A
SSE 37 Series AAD-041S(M) 9V, 350 m A
XDECT R055
Series*
AAD-041S(M) 9V, 350 m A
XDECT 8055
Series*
AAD-041S(M) 9V, 350 m A
XDECT 8015 Series PS-S0635YL3 6 V, 350m A
Elite 9135 Series AAD-041S(M) 9V, 350 m A
Applicable Uniden Phone Models & AC Adaptors
IMPORTANT INFORMATION
Battery Life under Power Failure
Talk Time Standby Time
Up to 1 hour Up to 1.5 hours BT-694x 1
Up to 2 hours Up to 3 hours BT-694x 2
Up to 3 hours Up to 4.5 hours BT-694x 3
* While the Base unit is powered by the battery box, its BASE LCD
backlight won’t flash.

5
ONEYEAR LIMITED WARRANTY
Terms of Warranty: Uniden Aust/NZ warrants to the original retail
purchaser only that the BP-100 (“the Product”), will be free from defects
in materials and craftsmanship for the duration of the warranty period,
subject to the limitations and exclusions set out below.
Warranty Period: This warranty to the original retail purchaser is only
valid in the original country of purchase for a Product first purchased
either in Australia or New Zealand and will expire one (1) year from the
date of the original retail sale. If a warranty claim is made, this warranty
will not apply if the Product is found by Uniden to be:
A. Damaged or not maintained in a reasonable manner or as
recommended in the relevant Uniden Owner’s Manual;
B. Modified, altered or used as part of any conversion kits,
subassemblies or any configurations not sold by Uniden Aust or
Uniden NZ;
C. Improperly installed contrary to instructions contained in the relevant
Owner’s Manual
D. Repaired by someone other than an authorized Uniden Repair Agent
in relation to a defect or malfunction covered by this warranty; or
E. Used in conjunction with any equipment, parts or a system
notmanufactured by Uniden.
Parts Covered:This warrantycoverstheProductandincludedaccessories.
User-generated Data: This warranty does not cover any claimed loss of
or damage to user-generated data (including but without limitation phone
numbers, addresses and images)that may be stored on your Product.
Satisfactory evidence of the original purchase is required for warranty
service. Please refer to our Uniden website for any details or warranty
durations offered in addition to those contained below.
The warrantor is either Uniden Australia Pty Limited ABN 58 001 865 498
(“Uniden Aust”) or Uniden New Zealand Limited (“Uniden NZ”) as the
case maybe.
BP-100
Important:
Warrantor:

6
Statement of Remedy: If the Product is found not to conform to this
warranty as stated above, the Warrantor, at its discretion, will either
repair the defect or replace the Product without any charge for parts or
service. This warranty does not include any reimbursement or payment
of any consequential damages claimed to arise from a Product’s failure to
comply with the warranty. Our goods come with guarantees that cannot
be excluded under the Australian Consumer Law. You are entitled to a
replacement or refund for a major failure and for compensation for any other
reasonably foreseeable loss or damage. You are also entitled to have the
goods repaired or replaced if the goods fail to be of acceptable quality and
the failure does not amount to a major failure. This warranty is in addition
to and sits alongside your rights under either the COMPETITION AND
CONSUMER ACT 2010 (Australia) or the CONSUMER GUARANTEES
ACT (New Zealand) as the case may be, none of which can be excluded.
Procedure for Obtaining Warranty Service: Depending on the
country in which the Product was first purchased, if you believe that
your Product does not conform with this warranty, you should deliver
the Product, together with satisfactory evidence of your original
purchase (such as a legible copy of the sales docket) to Uniden at the
addresses shown below. You should contact Uniden regarding any
compensation that may be payable for your expenses incurred in making
a warranty claim. Prior to delivery, we recommend that you make a
backup copy of any phone numbers, images or other data stored on
your Product, in case it is lost or damaged during warranty service.
UNIDEN AUSTRALIA PTY LTD
Service Division
345 Princes Highway,
Rockdale, NSW 2216
Phone number: 1300 366 895
Email: custser[email protected]
UNIDEN NEW ZEALAND LTD
Service Division
150 Harris Road, East Tamaki
Auckland 2013
Phone number: [phone]
Email: ser[email protected].nz

7

©2014 Uniden Australia Pty Ltd/Uniden New Zealand Limited
Printed in Vietnam U01UU298BZZ(0)