Unitech PA768 User manual

PA768 Gun Grip
Quick Start Guide
V1.0
Package
Pogo Pin on PA768/Gun Grip
Please make sure the following contents are in the
PA768 Gun Grip gift box. If something is missing or
damaged, please contact your Unitech representative.
•PA768 Gun Grip
•Wrist Strap
The Package Content
Please remove the following items from PA768
before using.
1. The Bottom Bumper
Getting Start
Getting Start (Continued)
2. The black mylar on the pogo pin (for gun grip)
3. The hand strap and fixed arm
Pogo pin of gun grip:
connected with PA768
via pogo pin
Pogo pin for gun grip

To ensure the unit working properly, please keep all connectors away
from the contaminants such as dust, grease, mud, and water.
Negligence may cause the unit to lose communication, short circuit, or
overheated. If the connector is damaged, please ensure the connector
is fully repaired before using the unit to avoid short circuiting.
WARNING!
There is a risk of fire and burns if the battery is handled improperly.
DO NOT disassemble, crush, puncture, short external contacts,
or dispose the battery pack in fire or water.
DO NOT attempt to open or service the battery.
Dispose used batteries according to local recycling guidelines in your area.
CAUTION!
http://www.ute.com/
Copyright 2023 Unitech Electronics Co., Ltd. All rights reserved.
Unitech is a registered trademark of Unitech Electronics Co., Ltd.
Assemble with Terminal
1. Align PA768 with the gun grip and insert from
about 45 degree angle.
2. Press down PA768 until you hear a click sound.
Make sure there is no gap between PA768 and
the gun grip.
Disassemble with Terminal
Grab two protrusions on both sides of gun grip,
and bent outward while pushing PA768 upward,
then you can remove it from the gun grip.