UNITED UHM-874 User manual

USER’S MANUAL
for MICA HEATER
Model: UHM-874
This product is only suitable for well insulated spaces or occasional use.
Please read this instruction manual carefully before operation!
Keep in a safe place for future reference.

General Safety Warning:
1. Read all instructions carefully before using.
2. Make sure the voltage is the same as that indicated on the rating plate of the
appliance.
3. Do not operate this appliance if the cable or plug becomes damaged.
4. Keep the appliance and cable away from sources of heat, sharp objects or anything
that may cause damage.
5. If the cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
6. Ensure that the appliance is switched off before connecting to the mains power
supply.
7. Switch off the power supply and disconnect from mains supply when not in use,
before cleaning or other maintenance.
8. Turn off the light Switch, disconnect the power supply.
9. The heater must not be located immediately below a socket-outlet.
10. Do not operate in areas where gasoline, paint or other flammable liquids are used
or stored.
11. Indoor use only.
12. In order to avoid overheating, do not cover the heater.
13. To prevent a possible fire, do not block air intakes or exhaust in any manner.
14. Don’t touch the hot surfaces.
15. Do not insert or allow foreign objects to enter any ventilation or exhaust opening,
as this may cause an electric shock, fire or damage to the appliance.
16. Always ensure that hands are dry before operating or adjusting any switch on the
product or touching the plug and socket-outlet.
17. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
18. Children should be supervised to ensure that they do not play with the appliance.
19. Do not leave this appliance unattended when it’s in use.
20. The most common cause of overheating is deposits of dust or fluff inside the
appliance. Ensure these deposits are removed regularly by and vacuum cleaning air
vents and grilles after disconnecting the appliance.
21. Do not place the heater on carpet, don’t place the cable under carpets. Arrange
cord away from traffic areas so that it will not be tripped over.
22. Do not use this heater in the immediate surroundings of a bath, a shower or a
swimming pool.

23. Do not store away until the heater cools down, store the heater in a cool and dry
location when not in use.
24. When in use, keep a distance between window(wall) of at least 50cm
25. Never use the product along with an automatic power-on programmer, timer or
other types of installations.
26. In case of product failure, please contact an after-sales service agent for inspection
and repairing. Unauthorized disassembling and replacement of parts are not allowed.
Technical Specifications:
Model
UHM-874
Rated Voltage
220 V -240V~
Rated Frequency
50 Hz
Rated Power
2000 W
Assembly
1. Insert the wheels into the bottom part of the supporting feet, and ensure they are
tight enough.
2. Put the appliance upside down, and fix the supporting feet onto the appliance
with the relative screws

Operation:
Connect the appliance to a suitable safety socket.
Turn on the switch to your desired heating position (I or II).
The heating functions(II )
Heat setting I
1000W
Heat setting II
2000W
Turn the thermostat knob clockwise until maximum temperature.
Once the room temperature is reached, slowly turn the thermostat knob
anticlockwise until you get your required temperature.
Turn the switch to “0” position to switch off the heater. Unplug the appliance
after use.
Overheat safety device
Your heater is fitted with a safety device that switches off the heater in the event
of overheating. If the safety device is activated, please turn the heater off, unplug
the appliance and let it completely cool down. Check whether the air inlet or
outlet are blocked, and then try to operate the heater again.
If the heater fails to operate or the safety device switches the heater off again,
return the heater to your nearest service center for examination or repair.
Maintenance:
1. Always disconnect the appliance and let it completely cool before any maintenance.
2. Use a vacuum cleaner to remove dust on grilles.
3. Clean the outside of the unit with a damp cloth and then dry it with a dry cloth.
Never immerse the unit in water, nor let water drip into the unit.
Storing:
1. Always disconnect the appliance, let it completely cool and clean it before storing.
2. If you do not use the device for a long period, put back the unit and the instruction
manual to the original carton and store in a dry and ventilated place.
3. Do not place any heavy items on top of carton during storing as this may damage
the appliance.

NOTICE ABOUT RECYCLING
Your product is designed and manufactured with high quality
materials and components which can be recycled and reused.
This symbol means that electrical and electronic equipment, at their
end-of-life, should be disposed of separately from your household
waste. Please dispose of this equipment at your local community
waste collection/ recycling centre.
In the European Union there are separate collection systems for used electrical and
electronic products.
Please help us to conserve the environment we live in!
DECLARATION OF CONFORMITY
Herewith, Amiridis-Savvidis S.A. states that this product, complies with the
requirements of below directives:
EMC-Directive: 14 / 30 / EU
Low Voltage Directive: 14/ 35 / EU
ErP Directive 09 / 125 / EC
CE Marking: 93 / 68 / EEC
RoHS Directive: 11 / 65 / EU
The detailed declaration of conformity can be found at www.united-electronics.gr
Exclusive importer in Greece:
Amiridis – Savvidis S.A.
87A, 17th Noemvriou str, P.C. 55534
Thessaloniki – Greece
T: [phone] | F: [phone]
www.amiridis-savvidis.gr