UNITED UHQ-857 User manual

INSTRUCTION MANUAL
FOR QUARTZ HEATER
UHQ-857
Read these instructions carefully and keep them for
future reference

DESCRIPTION
Voltage: 220~240V
Frequency:50/60Hz
Two heating power:1100W/2200W
Quartz heating element
With thermostat protection
Tip-over switch protection
ASSEMBLY
1. Carefully turn the appliance upside down to fit the castors.
2. Slide the wheel plate at the right position.
3. Secure the wheel plate by lightening the butterfly nut.
4. Put the appliance in the upright position.
5. Take out the cable from the cable bracket backside.
OPERATION
1. Switch the heater to one of the following power settings:
 I – low heating power;
 II – high heating power;
NOTE!
This device will cool slowly after the power is shut off. Allow the heater to cool prior to
any movement. The built-in carry handle should be used for easy movement.
When this device is overheated it is automatically turned off by a special security
system. Unplug the device and let it cool down before activating it again.
2. Once you finished using the heater, turn the power switches to the “OFF” position,
then unplug the main power supply.
CLEANING
1. If not used for a long time, clean the heater’s surface and keep it in the original
packing. Keep the heater in airy place and pay attention to avoid dampness.
2. Use a damp cloth to clean the surface of appliance, avoid water going inside the
appliance, and dry the appliance before use or store.

STORAGE
1. Save the original packing for the off-season storage.
2. Clean the heater according to the cleaning instructions above.
3. Remove the wheel base assemblies.
4. Place the heater and the wheel assemblies in the original packing and store in dry
place.
SAFETY REGULATIONS
1. The heater should be put and used in the suitable place, forbid putting the heater under
the power socket.
2. In the range that can be radiated around the heater, forbid putting flammable, in
accordance with explosion articles. The occasion that can’t be used which is full of
flammable gas and dust either.
3. The heater should be more than 1 meter away from the flammable material, and avoid
the fixed irradiation for a long time.
4. The heater should be put on a smooth solid tabletop or ground to work.
5. The cable should be put well, and avoid tripping over the heater while walking, the cable
must keep away the top part of the heater, forbid the cable touch the radiation cover and
the net cover, forbid being heated by the infrared closely.
6. Can't hang the clothes dripping or drench with rain above the heater, avoid entering
water and leaking electricity dangerously, avoid covering flammable things on the
radiation cover and the net cover, avoid taking place the fire and get an electric shock
dangerously.
7. The socket cable should keep in touch the ground well, should select the qualified
socket.
8. The voltage of the power, frequency should accord with the technical parameter request
of the heater.
9. Ammeter and cable connecting up inside must load the power of heater, also should
consider of loading other electric appliances at the same time.
10. Forbid touching the radiation cover when it is working, in order to prevent the high
temperature from scalding the skin.
11. Forbid working when pull down the net cover.
12. When stop using, should pull out the plug carefully, and turn off the heater before
pulling out, don't draw cable with hand.
13. Should pack the machine well when won’t use it for a long time, prevent the dust,
deposit to a dry and ventilate place.
14. When only child, animal, people lack for self-control or difficulty moving themselves in
the room, and nobody nurse them, should avoid using it.
15. In case heater is not equiped with device to control the room temperature, don’t use this
heater in small room where they are occupied by person not capable of leaving the room
on their own unless consistent supervision is provided.
16. If the machine couldn’t work normally, please contact the after-sale service for repair,
avoid breaking it down and change the fittings without permission.
17. When it is covered or furnished in a incorrect position, it may catch fire, so please don't
set the heater as starting automatically; It must be turned off when the electrical power is

cut, avoid working automatically when the incoming electricity and nobody in the room..
18. When the heater which deposit in -20℃ severe cold place, must intensify it above -20℃
before using it, prevent material from changing the characteristic in the low temperature.
19. Do not use this heater with a programmer, timer or any other device that switches the
heater on automatically, since a fire risk exists if the heater is covered or positioned
incorrectly.
20. Do not use this heater in the immediate surroundings of a bath, a shower or a swimming
pool.
21. WARNING: In order to avoid overheating, do not cover the heater.
22. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
23. The appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
24. Children should be supervised to ensure that they do not play with the appliance.
SAFEGUARD AND MAINTAIN
1. Please pull out the plug and cool it to the normal temperature before safeguarding and
maintaining.
2. It’s easy to accumulate of dust on the appearance, should clean it frequently with soft
cloth. Must pull down the screws and nut, take off the net cover before cleaning the inner
surface of the radiation cover. Avoid using a wet or flammable soft cloth to clean the
heat device, also avoid hanging soft cloth or other flammable things on it. It must set up
the net cover and fix the screws after cleaning.
3. When the surface is too dirty, could be polished with water lower than 50℃ and mixed
with neutral detergent, then dry it.
4. When do cleaning, avoid using the petrol, diluent, sour things or any other chemical
things and the materials which may damage the heaters’ surface easily.
5. Should cool it to the normal temperature, dry it, and pack it carefully, then deposit to a
dry and ventilative place.
OBSTACLE ELIMINATE
1. If the heater don’t heat up after starting the machine, please check whether the power is
normal, whether the socket is good, retry it after checking carefully.
2. Please send it to the service department for other obstacles.
3. There is safety switch at the bottom of the heater, and when it fall down, the switch
would cut off the electricity automatically, and it stop working, make it perpendicularity
and turn on the machine, it would be working normally.

NOTICE ABOUT RECYCLING
Your product is designed and manufactured with high quality materials and
components which can be recycled and reused.
This symbol means that electrical and electronic equipment, at their end-of-life,
should be disposed of separately from your household waste. Please dispose of
this equipment at your local community waste collection/ recycling centre.
In the European Union there are separate collection systems for used electrical
and electronic products.
Please help us to conserve the environment we live in!
DECLARATION OF CONFORMITY
Herewith, Amiridis-Savvidis S.A. states that this product, complies with the
requirements of below directives:
EMC-Directive: 14 / 30 / EU
Low Voltage Directive: 14/ 35 / EU
CE Marking: 93 / 68 / EEC
ErP Directive 09/125/EC
RoHS Directive: 11 / 65 / EU
The detailed declaration of conformity can be found at www.united-electronics.gr
Exclusive importer in Greece:
Amiridis – Savvidis S.A.
87A, 17th Noemvriou str, P.C. 55534
Thessaloniki – Greece
T: [phone] | F: [phone]
www.amiridis-savvidis.gr