UNITED UHQ-857 User manual

INSTRUCTION MANUAL
QUARTZ HEATER
UHQ-857
Read these instructions carefully and keep them for future reference.
This product is suitable for outdoor use only

DESCRIPTION
Voltage: 220~240V
Frequency:50/60Hz
Two heating power: 1100W/2200W
Quartz heating element
With thermostat protection
Tip-over switch protection
ASSEMBLY
1. Carefully turn the appliance upside down to fit the castors.
2. Slide the wheel plate at the right position.
3. Secure the wheel plate by tightening the butterfly nut.
4. Put the appliance in the upright position.
5. Take out the cable from the cable bracket backside.
OPERATION
1. Switch the heater to one of the following power settings:
•I – low heating power;
•II – high heating power
NOTE!
This device will cool slowly after the power is shut off. Allow the heater to cool
prior to any movement. The built-in carry handle should be used for easy
movement.
When this device is overheated it is automatically turned off by a
special security system.
Unplug the device and let it cool down before activating it again.
2. Once you finished using the heater, turn the power switches to the “OFF”
position, then unplug the main power supply.
This product is suitable for outdoor use only.

STORAGE
1. Save the original packing for the off-season storage.
2. Clean the heater according to the cleaning instructions above.
3. Remove the wheel base assemblies.
4. Place the heater and the wheel assemblies in the original packing and
store in dry and cool place.
SAFETY REGULATIONS
1. The heater should be put and used in the suitable place. It is forbidden to
place the heater under the power socket.
2. In the range that can be radiated around the heater, forbid putting flammable, in
accordance with explosion articles. The occasion that can’t be used which is full
of flammable gas and dust either.
3. The heater should be more than 1 meter away from the flammable material,
and avoid the fixed irradiation for a long time.
4. The heater should be put on a smooth solid tabletop or ground to work.
5. The cable should be put well, and avoid tripping over the heater while walking.
The cable must be kept away from top part of the heater. It is forbidden for the
cable to get in touch with the radiation cover and the net cover, also it is
forbidden being heated by the infrared closely.
6. DO NOT hang clothes or leave clothes dripping or drench with rain above the
heater. Avoid entering water and leaking electricity dangerously, avoid covering
flammable things on the radiation cover and on the net cover, avoid taking place
the fire and get an electric shock dangerously.
7. The socket cable should be well kept in touch with the ground. Use
ONLY a qualified socket.
8. The voltage of the power and the frequency should be according to the
technical parameters of the heater.
CLEANING
1. If it is not used for a long time, clean the heater’s surface and keep it in
the original packing. Keep the heater in airy place and pay attention to avoid
dampness.
2. Use a damp cloth to clean the surface of the appliance. Do not allow water
getting inside the appliance. Dry the appliance before using or storing it again.

18. When the heater is placed in severe cold place (-20℃), wait till the place gets
to normal temperature before turning it on. Otherwise the sudden change in
temperature may cause deformations in the device and lead to irreparable
damage.
19. Do not use this heater with a programmer, timer or any other device that
switches the heater on automatically, since a fire risk exists if the heater is
covered or misplaced.
20. Do not use this heater in the immediate surroundings of a bath, a shower or a
swimming pool.
21. WARNING: In order to avoid overheating, do not cover the heater.
22. If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
23. The appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
24. Children should be supervised to ensure that they do not play with the appliance.
14. Do not use the heater when unattended children, animals or people with
sensory and motor difficulties are near.
15. In case heater is not equiped with device to control the room temperature, don’t
use this heater in small room where they are occupied by person not capable of
leaving the room on their own unless consistent supervision is provided.
16. If the machine couldn’t work normally, please contact the after-sales service
for repair. Do not try breaking it down or change the fittings without permission.
17. When heater is covered or misplaced, there is a risk of fire so please do not
set it in utomatic start; It must be turned off when the electrical power is cut, to
avoid working automatically when the incoming electricity and nobody is around.
11. Forbid working when pull down the net cover.
12. When stop using, should pull out the plug carefully, and turn off the heater
before pulling out, don't draw cable with hand.
13. Please pack the heater well when you are planning not to use it for a
long time. Avoid dusty places. Put it in a dry and ventilated place.
9. Ammeter and cable connecting up inside must load the power of heater,
also should consider of loading other electric appliances at the same time.
10. Forbid touching the radiation cover when it is working, in order to prevent
the high temperature from scalding the skin.

SAFEGUARD AND MAINTAINANCE
1. Please pull out the plug and cool it to the normal temperature before
safeguarding and maintaining.
2. It’s easy to accumulate of dust on the appearance. It should be cleaned
frequently with a soft cloth. Pull down the screws and nut and take off the net
cover before cleaning the inner surface of the radiation cover. Avoid using a wet
or flammable soft cloth to clean the heat device; also avoid hanging soft cloth or
other flammable things on it. Set up the net cover and fix the screws every time
after cleaning.
3. When the surface is too dirty, polish it with water (lower than 50℃) mixed with
neutral detergent, then dry it.
4. When cleaning the device, avoid using petrol, diluent, sour things or any
other chemical solutions and / or materials which may damage the heaters’
surface easily.
5. Should cool it to the normal temperature, dry it, and pack it carefully, then
deposit to a dry and ventilative place.
TROUBLE SHOOTING
1. If the heater does not heat up after power on, please check whether the power is
normal, whether the socket is in good condition; after checking carefully you can
then retry.
2. Please send it to the service department for other obstacles.
3. There is safety switch at the bottom of the heater, and when it fall down, the
switch would cut off the electricity automatically, and it stop working, make it
perpendicularity and turn on the machine, it would be working normally.

NOTICE ABOUT RECYCLING
Your product is designed and manufactured with high quality materials and
components which can be recycled and reused.
This symbol means that electrical and electronic equipment, at their end-of-life,
should be disposed of separately from your household waste. Please dispose of
this equipment at your local community waste collection/ recycling centre.
In the European Union there are separate collection systems for used electrical
and electronic products.
Please help us to conserve the environment we live in!
DECLARATION OF CONFORMITY
Herewith, Kalliopi Karida & Co., LP. states that this product, complies with the
requirements of below directives:
EMC-Directive: 14 / 30 / EU
Low Voltage Directive: 14/ 35 / EU
RoHS Directive: 11/65/EU & 15/863/EU
amended by CE-marking Directive 93/68/EEC
The detailed declaration of conformity can be found at www.united-electronics.gr
Exclusive importer in Greece:
Kalliopi Karida & Co., LP.
87A, 17th Noemvriou str, P.C. 55534
Thessaloniki –Greece
T: [phone] | F: [phone]
www.united-electronics.gr