Universal Furniture Explore Home 07175H User manual

Page 1 of2
ASSEMBLY INSTRUCTIONS 07175H-75F-75R Louie P’s Sleigh Bed Queen 50
Thank you for purchasing this quality product. Be sure check all packing material carefully for small parts that
may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more
persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet.
Polish finish with soft cloth and an industry recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for stain
residue and rough
surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the
instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or
screwdrivers to prevent injury and scratching or damaging
flooring.
(4) During normal use every day, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
Note: Lay out all the parts and hardware to make sure the quantity of each is correct.

Page 2 of2
Step 1: Insert the threaded bolts (1) and the dowel (7) into the headboard (A) and footboard (B) as shown.
Attach side
rail (C) to headboard (A) and footboard (B) using curved washer (2), spring washer (3) and nut
(4). Tighten all bolts securely with wrench (5), but do not over tighten the bolts.
Step 2: Attach each support leg (E) into each slat (D).
Step 3: Attach each slat (D) to the side rails (C) using screw (6) as shown. Adjust the height of each
support leg (E)
by turning adjustable levelers located on the bottom of each support leg (E) clockwise to
lower and counterclockwise
to raise.
Assembly is now complete.