03
1.3 Appearance Introduction
1.
2.
If the system crashes, please press the power key for 3 seconds to
turn off the system.
If the problem sll can’t be fixed, please use a pin to press the
reset key to turn off the system.
sensor cover
3.5" touch panel
SD card slot
reset key
power key
DC power connector
mini USB port
battery cover
measure key
optical sensor
1.4 Annual Product Calibration
As the product is a high-precision instrument, please use it cauously.
To ensure the accuracy of measurements, annual calibraon is
recommended. Please consult the agent or the customer service
department for the calibraon service.
04
1.5 Product Notes and Precautions
PG100N Spectrometer is a high-precision instrument. Please unpack with care.
Any vibraon or collision may cause instrument damage. If the product doesn’t
work normally or needs repair, please don’t aempt any repairs. All repairs must
be performed by the authorized customer service agent.
Most LCD screens have a very small and inconsequenal defecve pixel rate
(usually less than 0.1%). This results in occasional pinpoints of white or other
colors but will not affect the accuracy of measurements.
1.
2.
Precautions / Warnings
Please read the following precauons to avoid fire, excessive heat, chemical leakage
and explosion :
Do not disassemble or modify the baery.
Do not expose the baery to heat (fire) or water/moisture.
When disposing used/old baeries, wrap with insulaon tape to shield the
baery from electrical contact with metallic objects, which might ignite a fire or
explosion.
If the unit is plugged into the power adapter and the baery seems to be
overheang, or if there is smoke or peculiar odors emanang from the unit,
unplug immediately to avoid the possibility of fire.
However, do not touch the cables if there is heat emanang from near the cables
as melted or deformed cables could expose wiring and result in burns or electric
shock.
Do not use cloth or anything to wrap or cover the equipment while charging –
this could cause the unit to overheat, melng the casing or causing fire.
If the unit is accidently immersed in water, or if moisture has seeped inside, or
metal objects have dropped into the casing, immediately remove the baery to
avoid fire or electric shock.
Do not operate or store the baery in high-temperature environments-it will
cause baery leakage and/or shorten the life of the baery .
Do not use paint thinner, benzene or other organic solvents to clean the
equipment – this may damage the exterior finish or touch screen, and may even
ignite fire.
■
■
■
■
■
■
■
■
■
