urmet domus VOG 5W System manual

DS1760-021 LBT21145
Mod.
1760
VIDEO DOOR PHONE 2VOICE HANDS-FREE WiFi
MONITEUR 2VOICE MAIN-LIBRES WiFi
VIDEOINTERFONO 2VOICE MANOS LIBRES WiFi
Sch./Ref. 1760/18
(white / blanc / blanco)
Sch./Ref. 1760/19
(black / noire / negro)
INSTALLATION HANDBOOK
NOTICE D’INSTALLATION
MANUAL DE INSTALACIÓN
FCC. ID.: REA176018

2DS1760-021
ENGLISH
1. DESCRIPTION
The video door phones Ref. 1760/18 and Ref. 1760/19 are dedicated to use in 2Voice video door
phone systems.
The main features are:
࠮ 5’’ (Wide Angle) TFT-LCD colour screen;
࠮ backlit soft-touch buttons (*);
࠮ possibility of activating video door phone functions using gesture commands on the IR sensor (disabled
by default);
࠮ possibility of adjusting the audio/video (speaker volume, brightness, contrastand colour)in OSD menu;
࠮ WVZZPIPSP[`VMJ\Z[VTPZPUN[OLYPUN[VULHJJVYKPUN[V[OLJHSSZV\YJL^P[OHJOVPJLVMÄ]LKPɈLYLU[[`WLZ;
࠮ possibility of adjusting the ring tone volume;
࠮ call forwarding function to smartphones and tablets;
࠮ video door phone answering machine function (up to 32 video messages);
࠮ users book for intercom calls (up to 32 users);
࠮ “Clean screen” function;
࠮ “MUTE” function;
࠮ hands-free or push-to-talk mode:
– Hands-free: press the audio button once to start the conversation and once again to end it;
– Push-to-talk: press the audio button to speak to the door unit, release the button to listen.
(*) When a key is pressed an acoustic signal (beep) is provided. This signal is disabled when “MUTE”
function is activated.
2. DESCRIPTION OF COMPONENTS AND FEATURES
12
13
14
15 1516
12
1
2
3
4
5
6
7
8
10
3
11
9
1. Function keys:
: driveway gate door opener key
: closing the contact between terminals X1 and X2 (max 50 mA @ 24 V )
: closing the contact between terminals Y1 and Y2 (max 50 mA @ 24 V )
: no function
: auto-on / video switching key

3
DS1760-021
: special function key
: intercom call key
: left scrolling arrow key
: right scrolling arrow key
: upwards scrolling arrow key
: downwards scrolling arrow key
: switchboard call key
2. Key for activation of secondary functions / display turning on (with green backlighting LED)
3. Raised notches for vision-impaired
4. Pedestrian door opener button (with green / red backlighting LED)
5. Function button (with red backlighting LED)
6. 5” display
7. Microphone
8. IR sensor for gesture commands
9. Micro SD slot
10. (\KPVVUVɈI\[[VU (with green backlighting LED)
11. Speaker
12. Terminals for connecting to the system
13. Jumper for adjustment of power supply type: System BUS or local power supply unit (JP1)
14. Jumper for adjustment of device consumption mode (JP2)
15. Jumper for adjustment of Z line termination (JP3)
16. *VUÄN\YH[PVUKPWZ^P[JOLZ (SW1 / SW2):
– UVVM:>KLÄULZ[OLVWLYH[PUNTVKLVU[OL>P-PVU[OL]PKLVKVVYWOVUL"
– VM:>[VKLÄUL[OLHWHY[TLU[U\TILYPU[OLJVS\TU"
– VM:>[VKLÄUL[OLZ[H[PVUU\TILYPU[OLHWHY[TLU[
SW1 SW2
= =
ON
ON
Refer to the system booklet for how to set the dip switches.
The video door phone is provided with a built-in hearing aid device, which only works during
video calls. Furthermore, the video door phone is equipped with two raised notches, positioned on the
sides next to the buttons and to help vision-impaired users locate the position of the two
buttons by touch.

4DS1760-021
3. INSTALLATION
ATTENTION! For proper operation of the Gesture commands, do not install the device in places
where it may be exposed to direct sunlight, as the IR detector is sensitive to light.
࠮ 0UZ[HSS[OLÅ\ZOTV\U[PUNIV_4VKVY[OLÅ\ZOTV\U[PUNIV_H[[OLOLPNO[PUKPJH[LKPU[OL
following drawing.
;OLÅ\ZOTV\U[PUNIV_4VKJHUILOVYPaVU[HSS`VY]LY[PJHSS`PUZ[HSSLK
࠮ Fix the bracket to the mounting box as indicated.
࠮ Program the dip-switches and connect the system wires to the terminal boards.
࠮ Fix the door phone to the bracket.
࠮ 9LTV]L[OLWYV[LJ[P]LÄSTMYVT[OLKPZWSH`
࠮ Power on the system.
ATTENTION! )HZLKVU[OLJVS\TUHKKYLZZJVUÄN\YLKVU[OL]PKLVKVVYWOVULZ[OLYLTH`ILHKLSH`PU
switching on.
1,50 m
Box Mod. 503
n° 2 M3,5 x 19 mm
provided n° 2 M3,5 x 19 mm countersunk screws
Box Ø 60 mm
1,50 m
n° 2 screws and screw
anchors included
1,55 m
2
1

5
DS1760-021
3.1. TERMINAL DESCRIPTION
Left terminal board
V- Terminals for local power supply unit Ref. 1760/110
V+
S- Negative for additional chime
S+ Positive for additional chime
X2
Button
X1
Y2
Button
Y1
Right terminal board
CP Floor call
PANIC Panic alarm
LINE OUT Power supply BUS output
LINE IN Power supply BUS input
3.2. JUMPER AND DIP-SWITCH SW1 NO.1 (DEFAULT)
JP1
JP2
JP3

6DS1760-021
JUMPER (JP3)
The following Jumper allows to adjust the line termination (Z) in case of in-out video door phone connection.
The line termination must be inserted into the last video door phone.
JP3
Termination inserted (default)
Termination not inserted
For position of jumpers JP1 and JP2 and dip-switch SW1 no.1 refer to the next chapter of the following
handbook.
4. VIDEO DOOR PHONE PERFORMANCE ACCORDING TO
CONFIGURATION METHOD
;OL]PKLVKVVYWOVULJHUILJVUÄN\YH[LK^P[OKPɈLYLU[TL[OVKZ+LWLUKPUNVU[OLZLSLJ[LKTL[OVK
limitation will be present on the following performance.
Installation type (*)
Performance Low rise block (Default)
(Power supply from
system BUS with WiFi
always active)
High rise block
(Power supply from
system BUS with
WiFi active after call
forwarding)
Local power
(Power supply from
local power supply unit
Ref. 1760/110)
Jumpers and DIP-
switches
JP1
JP2
SW1 n.1
=
ON
JP1
JP2
SW1 n.1
=
ON
JP1
JP2
SW1 n.1
=
ON
Delay time on
reception of call
forwarding to CallMe
app
No delay 10 seconds No delay
CallMe app auto-on Available Not available Available
Panic alarm signalling
to CallMe App Available Not available Available

7
DS1760-021
Automatic door
opener timing Not available Available Available
Screen displaying
during intercom
and switchboard calls
Not available Not available Available
Number of video door
phones in riser
Reduction of video door
phone number (*)
Reduction of video
door phone number (*) 127
Display turning on 1 video door phone at a
time in riser
1 video door phone at
a time in riser Unlimited
Display turning on
duration 5 minutes 5 minutes Unlimited
Display timeout time
for inactivity 30 seconds 30 seconds 60 seconds
(*) For the limits of the number of video door entry phone in the riser column, refer to the chapter “Video
door phone installation constraints”.
5. VIDEO DOOR PHONE INSTALLATION CONSTRAINTS
0M [OL JVUÄN\YH[PVU TVKL ¸Low rise block” is used on the1760/18 - / 19 video door phones you
can have a reduction in the number of video door phone in a riser column derived from a column distributor
Ref. 1083/53 or a column interface Ref. 1083/50, with the same maximum distances
Reduction is as follows:
Power supply Cable type Number of video door phones
1083/20A 2Voice Ref. 1083/92 - /94 16
CAT5 UTP (one twisted pair) 8
1083/23 2Voice Ref. 1083/92 - /94 5
CAT5 UTP (one twisted pair) 3
ATTENTION! Any Slave video door phones Ref. 1760/18 - /19 present in the apartments must be powered
^P[O [OL SVJHS WV^LY Z\WWS` \UP[ HUK JVUÄN\YLK in Local power mode.
If the video door phone Ref. 1760/18 or /19 is installed as a spare to replace a video door phone, it must be
WV^LYLK [OYV\NO [OL SVJHS WV^LY Z\WWS` HUK JVUÄN\YLK ^P[O [OL Local power mode of use.
For other types of cables, see the booklet “Limit number of ]PKLVKVVYWOVULZPUYPZLY+:¹
on the Urmet website by scanning the following QR Code.

8DS1760-021
6. CONTACT INSERTION FOR INTERCOM CALLS
In order to make intercom calls, it is necessary to enter contacts in the video door phone book. Up to 32
contacts can be entered.
To enter a new contact, proceed as follows:
࠮ Press the key twice when the video door phone is in stand-by mode to turn on the display and
view the Homepage.
For video door phones powered in High rise block and Low rise block, access to the Homepage is
WLYTP[[LK[VVULKL]PJLH[H[PTLMVYHTH_PT\TVMTPU\[LZ0MH\ZLY[YPLZ[VHJJLZZ[OL/VTLWHNL
when it is already in use on another device, the video door phone will emit a dissuasion tone (4 beeps)
indicating that the page cannot be displayed at the moment.
࠮ The display shows the following screen:
࠮ Press keys , , and to select the following icon .
࠮ When selection has been made press the key [VJVUÄYT
࠮ The display shows the following screen:
࠮ 0U[OLJVUÄN\YH[PVUTLU\WYLZZ[OLRL` until selecting “Contacts”.
࠮ Press the key [VJVUÄYT[OLZLSLJ[PVU

9
DS1760-021
࠮ To enter an new contact, press the key and select the icon to add a new contact .
࠮ Press the key [VJVUÄYTHUKKPZWSH`[OLMVSSV^PUNZJYLLU!
࠮ ;OLMVSSV^PUNWHYHTL[LYZT\Z[ILKLÄULKMVYLHJOUL^JVU[HJ[!
1. Contact type
Press the key to select the following icon , then press the key to change the contact type.
࠮ External contact: call to a video door phone in another apartment but within the same video
door phone riser
࠮ Internal contact: call to a video door phone in the same apartment
2. Video door phone ID code
Press the key to select the following icon , then press the key to enter the video door phone
ID code.
࠮ For external contacts, permissible codes range from 0 to 126
࠮ For internal contacts, permissible codes range from 0 to 3
 0U[OLJVUÄN\YH[PVUTLU\\UKLY¸System information¹P[PZWVZZPISL[V]PL^[OL0+JVKLVM]PKLV
door phones (for more details see the 7HYHTL[LYJVUÄN\YH[PVUOHUKIVVR available by scanning the
QR-Code at the end of the handbook).

10 DS1760-021
Press the keys , , and to select on the virtual keypad the numbers that make up the video
door phone ID code you want to add to the contacts. Press the key [VJVUÄYT[OLZLSLJ[LKU\TILY
3. Contact name
Press the keys , , and to select the following icon , then press the key
to enter the contact name.
Press the keys , , and to use the virtual keypad and enter the contact name. Press the key
[VJVUÄYT[OLJOHYHJ[LYZ[VILLU[LYLK
࠮ Finally, press the key to quit the contact insertion page, the display shows the following screen
page:
࠮ Press the key to save the contact in the book. Press the key to cancel and return to the
contact page.