V-tech LS5105 - Cordless Extension Handset User manual

Quick start guide for model LS5105
Battery installation
Install the battery as shown below.
Press the tab and slide
the battery compartment
cover downwards.
1. Insert the plug as indicated.
Make sure it is plugged
securely and matches the
color-coded label inside the
battery compartment.
2.
Place the battery with
the label THIS SIDE
UP facing up and the
wires inside the battery
compartment.
3. Align the cover at against
the battery compartment,
then slide it upwards until
it clicks into place.
4. Charger
Electrical outlet
not controlled by
a wall switch Power
adapter
Charge light
Battery charging
For optimal performance, charge the handset battery for at least 16
hours before use.
Registering a handset
To register a new handset:
1. Place the unregistered handset in the
telephone base.
2. Press the MENU softkey on the telephone
base while in idle mode.
3. Press the UP and DOWN Navkeys to
highlight Register Handset, then press the
SELECT softkey.
Registering Handset will appear on the
telephone base display.
Registration in progress... will appear on
the handset display.
The registration process may take up to
90 seconds to complete.
When the registration process is complete, the
telephone base and handset will generate a
conrmation tone. The newly registered handset will
be assigned the next handset registration number.
•
•
•
12:00AM
Registration
in progress...
12:00AM
Place in
Charger
12:00AM
Register handset:
Press MENU in the
base. Find 'Register
Handset' in the Main
Menu. Press SELECT.
THIS SIDE UP
BatteryPack BT5632/ BT5872 3.6V550mAh Ni-MH WARNING:DONOT BURN OR PUNCTURE BATTERIES MADEIN CHINA
THIS SIDE UP
Battery Pack BT5632 / BT5872 3.6V 550mAh Ni-MH WARNING:DO NOT BURN OR PUNCTURE BATTERIES MADE IN CHINA
THIS SIDE UP
BatteryPack BT5632/ BT5872 3.6V550mAh Ni-MH WARNING:DO NOT BURN OR PUNCTURE BATTERIES MADEIN CHINA
THIS SIDE UP
BatteryPack BT5632/ BT5872 3.6V550mAh Ni-MH WARNING:DO NOT BURN OR PUNCTURE BATTERIES MADEIN CHINA
NOTE:
Use only the power adapter and battery supplied with your VTech
telephone.

Replacing a handset
When you are replacing rather than adding a
handset, you need to delete all the handset
registrations from the telephone base for the
handsets to be numbered sequentially.
To delete registration on all handsets:
Press the MENU softkey on the telephone
base when in idle mode to enter the main
menu.
Press the UP and DOWN NavKeys to select
Settings, then press the SELECT softkey to
enter the Settings menu.
Press the UP and DOWN NavKeys to
highlight Delete Handsets, then press the
SELECT softkey. The screen will show
Delete Registration of all handsets?
Press the YES softkey.
After deleting the registrations of all handsets,
you will need to register each handset individually
with the telephone base.
1.
2.
3.
4.
Settings
Voice Mail Codes
Default Settings
Delete Handsets
SELECT
Delete Handsets
NO
YES
Delete Registration
of all handsets?
NOTE:
For complete feature instructions, please refer to your user’s
manual.
IMPORTANT!
If your product is not working properly:
Refer to the Troubleshooting section of the user’s manual.
Visit our website at www.vtechphones.com or call
1 [phone]. In Canada, go to www.vtechcanada.com
or 1 [phone].
•
•
96-006551-010-100
issue 0