V-tech Go! Go! Smart Wheels Rescue Tower Firehouse User manual

Instruction Manual
Rescue Tower Firehouse
™

2
INTRODUCTION
Thank you for purchasing the VTech®Go! Go! Smart Wheels®Rescue
Tower FirehouseTM.This Fearless Fire Truck is comin’ to the rescue!
Little ones will explore role-play excitement with the Fire Station. Press
the bell button to sound the alarm and launch the Fire Truck into the
action! Hear phrases, music and sounds when your vehicle responds
to the four SmartPoint®locations.
SmartPoint®Fire Truck
4 SmartPoint®Locations
Elevator
4 Accessories
( Fire, Fire
Extinguisher, Fire
Hydrant, Dog)

3
INCLUDED IN THE PACKAGE
One training tower
with a bell
Ramp track A Ramp track B
Road supports, right
One fire
extinguisher
Ramp track D
One fire
One dog
One SmartPoint®
Fire Station
Ramp track C
One fire hydrant
One gate

4
One elevator
platform (J)
One elevator track
(K)
One launcher
piece (L)
One back wall (G) One gate top (H) One gate floor (I)
One building base
(M)
One fire brand (N) One right wall (O)
Two gate fronts
(E)
Road supports,
left
Three road
support-middles (F)

5
• Sticker Sheet
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child’s safety.
NOTE
Please save this manual as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les produits
d’emballage tels que rubans adhésifs, feuilles de plastique, attaches,
étiquettes, cordons et vis d’emballage. Ils ne font pas partie du jouet.
NOTE
Il est conseillé de sauvegarder ce manuel car il comporte des
informations importantes.
If there are no locks inside the package, disregard this message.
Removing the Packaging Locks:
Pull out the packaging locks and discard.
Turn the packaging locks anticlockwise
several times.

6
INSTRUCTIONS
Battery Removal And Installation
1. Make sure the unit is turned OFF.
2. Find the battery cover located on
the bottom of the Fire Truck, use a
screwdriver to loosen the screw and
then open the battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AAA (AM-4/LR03)
batteries following the diagram inside
the battery box. (For best performance, alkaline batteries or fully
charged Ni-MH rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
MPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended are
to be used.
• Do not short-circuit the supply terminals.

7
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES
• Remove rechargeable batteries (if removable) from the toy before
charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.
IMPORTANT : INFORMATIONS CONCERNANT LES PILES
• Mettre en place les piles ou les accumulateurs en respectant les
polarités + et –.
• Ne pas mélanger des piles ou des accumulateurs neufs avec des
usagés.
• Ne pas mélanger différents types de piles : alcalines, zinc-carbone
et rechargeables.
• Seules des piles du type recommandé doivent être utilisées.
• Ne pas mettre les bornes d’une pile ou d’un accumulateur en court-
circuit (en reliant directement le + et le –).
• Retirer les piles ou les accumulateurs en cas de non-utilisation
prolongée.
• Enlever les piles ou les accumulateurs usagés du jouet.
• Ne les jeter ni au feu ni dans la nature.
PILES RECHARGEABLES
• Enlever, lorsque c’est possible, les accumulateurs du jouet pour
les recharger.
• Les accumulateurs ne doivent être chargés que sous la surveillance
d’un adulte.
• Ne pas tenter de recharger des piles non rechargeables.

8
123
4
6
7
8
9
10
5
LABEL APPLICATION
Please stick the labels to the play set as shown below:
6
1
2
3
7
5
4
8
9
10

9
ASSEMBLY INSTRUCTIONS
1. Assemble gates, gate floor and wall components by following the
steps below:
A. Snap the two Gate fronts (E) to the Gate floor(I). Insert the side
with a 1 on the back on the left of the Gate floor (I) and the side with
a 2 on the back on the right of the Gate floor (I) (see below). Then
insert the Gate in the two grooves in the base as shown.
B. Set the Gate top (H) on the Gate fronts (see below). Attach
the Back wall (G) using tabs on the Gate floor and Gate top. You
will hear a clicking sound.
With the Go! Go! Smart Wheels Rescue Tower Firehouse, safety
comes first. To ensure your child’s safety, adult assembly is required.
12

10
C. Attach the Right wall (O) to the Gate floor and gate top support,
as shown. Connect the Elevator track (K) to the Right wall (O).
2. Assemble the tracks and components on the left side of the playset
following the steps below:
A. Snap the Ramp track B and Ramp track C together, then Insert
Road support right and Road support left in the groove of Ramp
track C.
B. Insert Ramp track A into the groove of Ramp track C.