V-tech Go ! Go ! Smart Wheels Supercharged Monster Truck... User manual

Supercharged Monster Truck RallyTM
Instruction Manual
91-003998-000 US

2
Platform
Launcher
Jump
Launcher
Landing Ramp
Bridge
INTRODUCTION
Thank you for purchasing the Go! Go! Smart Wheels®Supercharged
Monster Truck RallyTM.
Little racers love performing all the stunts on this wild ride! Launch
the Monster Truck off of one of two launchers and create multiple
configurations for even more fun. Plus, hear fun music and sound
effects when the vehicle responds to the four SmartPoint®locations.
It’s a great day to race!
4SmartPoint®
Locations
SmartPoint®
Monster Truck

3
INCLUDED IN THE PACKAGE
One SmartPoint®
Monster Truck
One jump launcher
base
One platform
launcher
Two 1/3 length
bulge track pieces
One stadium base
One fire awning
One slope track C
One stadium wall
One jump launcher
One landing ramp One slope track A One slope track B

4
Two cross tracks
Two platform
launcher supports
One switch track
One sign One sign base
One bridge
One end track
One S-track exit Two S-track supports
Three S-tracks One S-track platform
· Label sheet
· Quick Start Guide
A
A
A
B
B
B
C

5
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les produits
d’emballage tels que rubans adhésifs, feuilles de plastique, attaches,
étiquettes et vis d’emballage. Ils ne font pas partie du jouet.
NOTE
Il est conseillé de sauvegarder ce manuel d’instructions car il comporte
des informations importantes.
GETTING STARTED
Battery Removal and Installation
Monster Truck
1. Make sure the unit is turned Off.
2. Locate the battery cover on the
bottom of the Monster Truck. Use a
screwdriver to loosen the screw, then
open the battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 2 new AAA (AM-4/LR03)
batteries following the diagram inside
the battery box.
5. Replace the battery cover and tighten the screw to secure.
Unlock the Packaging Locks
Turn the packaging lock counterclockwise
several times.
Pull out the packaging lock and discard.

6
BATTERY NOTICE
• Insertbatterieswiththecorrectpolarity(+and-).
• Donotmixoldandnewbatteries.
• Donotmixalkaline,standard(carbon-zinc)orrechargeable
batteries.
• Onlybatteriesofthesameorequivalenttypeasrecommended
aretobeused.
• Donotshort-circuitthesupplyterminals.
• Removebatteriesduringlongperiodsofnon-use.
• Removeexhaustedbatteriesfromthetoy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinre.
RECHARGEABLE BATTERIES:
• Removerechargeablebatteriesfromthetoybeforecharging.
• Rechargeablebatteriesareonlytobechargedunderadult
supervision.
• Donotchargenon-rechargeablebatteries.

7
LABEL APPLICATION
Please apply the labels to the playset as shown below:
1
10
14
20
22
21
16
17
18
15
19
11
12
13
23
5
4
89

8
18
14
8
6
9
4
5
24
17
27
11
10
23
6
13
26
12
25
16
21
22
73
15 19
2
20

9
ASSEMBLY INSTRUCTIONS
With the Go! Go! Smart Wheels®Supercharged Monster Truck
RallyTM, safety comes first. To ensure your child’s safety, adult
assembly is required.
1. Connect the Platform Launcher and S-Track B with the Stadium
Wall.
2. Connect the Platform Launcher with S-Track A, and connect
S-Track A, S-Track C and Slope Track C with S-Track B.
3. Insert the Jump Launcher into the Jump Launcher Base, then
connect with Slope Track B and Cross Track B.

10
4. Insert the Sign into the Sign Base and connect with Cross Track
B. Then connect with Slope Track C and insert the Switch Track
into S-Track B.
5. Insert the two Platform Launcher Supports into the S-Track
Platform, then insert S-Track Support A into S-Track Support
B. Then connect S-Track Support A with S-Track Exit.
6. Connect S-Track C with S-Track Exit on the S-Track Platform.