V-tech Learn & Grow Farm Assembly Instructions

Parent’s Guide
91-004000-000 UK
Learn & Grow Farm

2
2
2
2
INTRODUCTION
Thank you for purchasing the Learn & Grow Farm!
Have fun with farming! Place any of the animals on one of the two
Talking Points to hear phrases and sounds. Three light up buttons
introduce time concepts and daily routines. Set up your farm with a
stable, tractor, animals and more. Let your imagination grow!
Talking Point
Circle
Talking Point
Rectangle
Barn
Stable
Windmill
On/Off/Volume
Selector
Shower
Lever
Electronic
Panel
Light Up
Buttons
Farmer & Animals
Silo

3
3
3
3
INCLUDED IN THE PACKAGE
One silo base
One stable base
One silo front
One stable wall
One silo back
One stable roof
One windmill bracket
One barn roof
One windmill base
One barn
One windmill
One field piece

4
4
4
4
One seesaw seat
One cart
One electronic
panel
Two gates
Four fences
One farmer
One barn base
One seesaw base
One tractor
One mouseOne butterfly sliderOne weather vane

5
5
5
5
One bundle
of wood
One bale of hay
- Label sheet
- Parent’s Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child’s safety.
NOTE
Please save this Parent’s Guide as it contains important information.
Four farm animals (Cow, Donkey, Chicken and Cat)

6
6
6
6
INSTRUCTIONS
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back
of the unit. Use a screwdriver to
loosen the screw. Then remove the
cover.
3. If used batteries are present,
remove these batteries from the unit
by pulling up on one end of each
battery.
4. Install 2 new AAA (AM-4/LR03)
batteries following the diagram inside
the battery box. (For best performance, alkaline batteries or fully
charged Ni-MH rechargeable batteries are recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.

7
7
7
7
IMPORTANT: BATTERY INFORMATION
•Insertbatterieswiththecorrectpolarity(+and-).•Donotmixoldandnewbatteries.•Donotmixalkaline,standard(carbon-zinc)orrechargeablebatteries.•Onlybatteriesofthesameorequivalenttypeasrecommendedare to be used.
•Donotshort-circuitthesupplyterminals.•Removebatteriesduringlongperiodsofnon-use.•Removeexhaustedbatteriesfromthetoy.•Disposeofbatteriessafely.Donotdisposeofbatteriesinfire.RECHARGEABLE BATTERIES:
•Removerechargeablebatteriesfromthetoybeforecharging.•Rechargeablebatteriesareonlytobechargedunderadultsupervision.•Donotchargenon-rechargeablebatteries.

8
8
8
8
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicate that the battery contains more than the specified
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out
in the Batteries and Accumulators Regulation.
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
VTech®cares for the planet.
Care for the environment and give your toy a second life by
disposing of it at a small electricals collection point so all its
materials can be recycled.
In the UK:
Visit www.recyclenow.com to see a list of collection points near you.
In Australia & New Zealand:
Check with you local council for kerbside collections.

9
9
9
9
15
14
16
LABEL APPLICATION
Please securely stick the labels to the play set as indicated on
the following pages:
1
10 11 12 13
23 4
5
6 7 89
1
8

10
10
10
10
ASSEMBLY INSTRUCTIONS
With the Learn & Grow Farm, safety comes first. To ensure your
child’s safety, adult assembly is required.
SMALL COMPONENT ASSEMBLY
1. Insert into
B
, then
C
as shown.You will hear a click sound
to indicate the pieces are secure.
2. Insert
E
into
D
, then insert into
F
. You will hear a click sound
to indicate the pieces are secure. Please note that they cannot
be detached once connected.
A
B
D
E
E
F
C
B