V-tech Pop-a-Balls Push & Pop Bulldozer Assembly Instructions

™
Parent’s Guide
Push & Pop Bulldozer™
91-009712-000

2
INTRODUCTION
Thank you for purchasing the VTech® Pop-a-Balls™ Push & Pop
BulldozerTM. The bulldozer comes to life when the colorful balls are
dropped into the cab of the bulldozer. Load the balls and push the
bulldozer to see the balls pop up through the smoke stack, into the
scoop bucket and back again.
Light-Up Driver
Button
On/Off/Volume
Control Switch
Smoke Stack
Tire Gear
Number
Buttons

3
INCLUDED IN THIS PACKAGE
• One Push & Pop BulldozerTM • Four balls
•One handle • Two large plugs
• Four small screws
• One parent’s guide
WARNING: All packing materials, such as tape, plastic
sheets, packaging locks, removable tags, cable
ties and packaging screws are not part of this toy,
and should be discarded for your child’s safety.
ATTENTION: Pour la sécurité de votre enfant, débarrassez-
vous de tous les produits d’emballage tels que
rubans adhésifs, feuilles de plastique, attaches,
étiquettes et vis d’emballage. Ils ne font pas
partie du jouet.
NOTE: Please keep this parent’s guide as it contains
important information.

4
Unlock the packaging locks:
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of
the bulldozer. Use a screwdriver to loosen
the screw.
3. Install 2 new AAA (AM-4/LR03) batteries
following the diagram inside the
battery box. (The use of new alkaline
batteries is recommended for maximum
performance.)
4. Replace the battery cover and tighten the
screw to secure.
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
Rotate the packaging locks 90 degrees
counter-clockwise.
Pull out the packaging locks.

5
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult
supervision.
ASSEMBLY INSTRUCTIONS
With the Push & Pop Bulldozer™, safety comes first. To ensure your
child’s safety, adult assembly is required.
1. Place the handle over the slot on the
bulldozer, making sure that the recessed
ball storage slots on the handle are facing
up. Place the two large plugs in the holes
on either side of the handle. Using a
screwdriver, secure two small screws into
each of the large plugs.
PRODUCT FEATURES
1. On/Off/Volume Control Switch
To turn the unit ON, slide the On/Off/
Volume Control Switch to the Low Volume
( ) or High Volume ( ) position.You
will hear a song and a welcoming phrase.
To turn the unit OFF, slide the On/Off/
Volume Control Switch to the OFF ( )
position.

6
2. Automatic Shut Off
To preserve battery life, the Push & Pop Bulldozer™ will automatically
power down after approximately 30 seconds without input.The unit can
be turned on again by pressing any button or twisting the tire gear.
NOTE: If the unit repeatedly powers down, we suggest changing the
batteries.
ACTIVITIES
1. Light-Up Driver Button
Press the Light-Up Driver Button to
hear a variety of playful phrases, songs,
sounds and short tunes. The light will
flash with the sounds.
2. Number Buttons
Press the Number Buttons to learn about
numbers, colors and construction objects,
and hear playful music and sounds. The
light will flash with the sounds.
3. Bulldozer Cab
Drop the colorful balls into the Bulldozer
Cab, then push the bulldozer forward to
see the scoop bucket move up and down
and the balls pop out of the Smoke Stack.
The balls will be counted as they pop out
of the Smoke Stack. The light will flash
with the sounds.

7
4. Smoke Stack
Drop a ball into the Smoke Stack to hear
fun sounds. The light will flash with the
sounds.
5. Tire Gear
Twist the Tire Gear to the left then release
to manually pop the balls out of the
Smoke Stack. You will hear a variety of
fun sounds or a short tune. The light will
flash with the sounds.
Note: Please avoid inserting feet and arms into the bulldozer cab
and smoke stack. When there is only one ball left in the smoke
stack, you will need to use the tire gear to pop the ball out or
add more balls to the bulldozer cab and push the bulldozer.
SONG LIST
SONG 1
I’ve been working in my bulldozer,
All the live long day.
I’ve been working in my bulldozer,
Scooping the balls away.
SONG 2
Scoop, scoop, scoop the balls.
Clear them off the ground.
One, two, three, four,
How many have you found?
SONG 3
Scooping up, cleaning the site.
Every single day and night!

8
MELODY LIST
1. I’ve Been Working on the Railroad
2. Row, Row, Row Your Boat
3. Swing Low, Sweet Chariot
4. Turkey in the Straw
5. When the Saints Go Marching In
6. One Man Went to Mow a Meadow
7. Yankee Doodle
8. Blow the Man Down
9. BINGO
10. The Wheels on the Bus
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2.
Keep the unit out of direct sunlight and away from any direct heat
source.
3. Remove the batteries when the unit will not be in use for an
extended period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
If for some reason the program/activity stops working or malfunctions,
please follow these steps:
1. Please turn the unit OFF.
2. Interrupt the power supply by removing the batteries.
3. Let the unit sit for a few minutes, then replace the batteries.
4. Turn the unit ON. The unit should now be ready to play again.
5. If the product still does not work, replace with an entire set of new
batteries.

9
If the problem persists, please call our Consumer Services Department
at 1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada, or by
going to our website at vtechkids.com and filling out our Contact Us
form located under the Customer Support link. A service representative
will be happy to help you.
IMPORTANT NOTE:
Creating and developing VTech®products is accompanied by a
responsibility that we at VTech®take very seriously. We make
every effort to ensure the accuracy of the information, which forms
the value of our products. However, errors sometimes can occur.
It is important for you to know that we stand behind our products
and encourage you to call our Consumer Services Department at
1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada, or by
going to our website at vtechkids.com and filling out our Contact Us
form located under the Customer Support link with any problems
and/or suggestions that you might have. A service representative
will be happy to help you.
Note:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:

10
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
CAN ICES-3 (B)/NMB-3(B)
Caution: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
CAUTION:
ATTENTION !