V-tech Switch & Go Dinos RESCUE RAIDERS 3-IN-1 User manual

Instruction Manual
RESCUE RAIDERS 3-IN-1RESCUE RAIDERS 3-IN-1
®

C
M
Y
CM
MY
CY
CMY
K
Grow with VTech(101x127)bw1P-V2.pdf 1 08/18/2014 9:29:01

3
INTRODUCTION
Switch into fun with the Switch & Go Dinos®Rescue Raiders 3-In-1!
Combine these 3 rescue vehicles into a mega rescue T-Rex. Split the
T-Rex apart and send each vehicle on separate rescue missions. Let’s go!
LCD Screen
LED Light
Light Button
Talk Button
Off/Low/High
Volume Switch
LED Light

4
INCLUDED IN THE PACKAGE
• Switch & Go Dinos®Rescue Raiders 3-In-1
• Quick Start Guide
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not
part of this toy, and should be discarded for your child’s safety.
NOTE
Please save this manual as it contains important information.
GETTING STARTED
The Rescue Raiders 3-In-1 is in try-me mode in the packaging. To
exit try-me mode, switch from “Dino Head Mode” to “Vehicle Mode”
or connect the Dino Head to the Dino Body (Rescue Helicopter).
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.

5
Battery Removal and Installation
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the
back of the unit. Use a screwdriver
to loosen the screw and then open
the battery cover.
3. If used batteries are present,
remove these batteries from the
unit by pulling up on one end of
each battery.
4. Install 2 new AA (AM-3/LR6) batteries following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended).
5. Replace the battery cover and tighten the screw to secure.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES
• Remove rechargeable batteries (if removable) from toy before
charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.

6
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked, indicate
that the battery contains more than the specified value of
mercury (Hg), cadmium (Cd) or lead (Pb) set out in the
Batteries and Accumulators Regulation.
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Please dispose of your product and batteries responsibly.
In the UK, give this toy a second life by disposing of it at a small
electricals collection point* so all of its materials can be recycled.
Learn more at:
www.vtech.co.uk/recycle
www.vtech.com.au/sustainability
* Visit www.recyclenow.com to see a list of collection points near you.

7
PRODUCT FEATURES
1. Off/Low/High Volume Switch
To turn the unit On or adjust the
volume, slide the switch to the Low
or High volume position. To turn
the unit Off, slide the switch to the Off
position.
2. Talk Button
Press the Talk Button to hear fun
phrases and cool dino sounds with
light effects in T-Rex mode,or to hear
fun phrases and police car sounds in
Vehicle mode.
3. Light Button
Press the Light Button to trigger cool
light effects with sound effects.
4. LCD Screen
The LCD Screen shows dino eye
animations in Dino mode and shows
driver animations in Vehicle mode.

8
5. Automatic Shut-Off
To preserve battery life, the unit will automatically shut off after
approximately 20 seconds without input. The unit can be turned
on again by pressing the Game Button, Light Button, or by
switching between Dino Head mode and Vehicle mode, or by
attaching the dino head to the dino body. The unit will also
automatically turn off when battery power is very low.
NOTE
If the unit powers down, or if the light fades out during play, please
install a new set of batteries.
HOW TO SWITCH
Switching from Dino Head Mode to Police Car Mode
1. Begin in Dino Head Mode.
2. Flip the windscreen back and flip up the Dino’s mouth.

9
3. Flip the jaw cover backward.
4. Swing the side panels out and fold them forward.
Brion Brion

10
5. The Dino Head is now in Police Car Mode.
Switching from Helicopter Mode to Dino Body Mode
1. Begin in Helicopter Mode.
2. Flip both landing skids out.

11
3. Rotate 2 of the rotor blades towards the centre.
4. Rotate both arms up and then flip the claws out.
5. Flip the helicopter tail under the body of the helicopter.

12
6. The Helicopter is now in Dino Body Mode.
Switching from Fire Engine Mode to Dino Legs Mode
1. Begin in Fire Engine Mode.
2. Flip the base cover to the front.

13
3. Swing both legs forward.
4. Flip the ladder back.
5. Swing the feet out.

14
6. Flip the toes forward.
7. Flip the legs down.
8. Spread the toes for additional stability.

15
9. Flip the cab of the fire engine up.
NOTE
To switch the Dino Head, Dino Body and Dino Legs back into the
Police Car, Helicopter and Fire Engine, follow the above steps in
reverse order.
COMBINATION
1. Combine the Dino Body with the Dino Legs.
10. The Fire Engine is now in Dino Legs Mode.

16
2. Snap the Dino Head to the Dino Body.
3. The combined Rescue Raiders are now in Rescue Rex Mode.
NOTE
To separate the T-Rex into the Dino Head, Dino Body and Dino Legs,
follow the above steps in reverse order.

17
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
sources.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please
follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, install a new set of batteries.

18
CONSUMER SERVICES
Creating and developing VTech®products is accompanied by a
responsibility that we at VTech®take very seriously. We make every
effort to ensure the accuracy of the information, which forms the
value of our products. However, errors sometimes can occur. It is
important for you to know that we stand behind our products and
encourage you to call our Consumer Services Department with
any problems and/or suggestions that you might have. A service
representative will be happy to help you.
UK Customers:
Phone: [phone] (from UK) or [phone] (outside UK)
Website: www.vtech.co.uk/support
Australian Customers:
Phone: [phone]
Website: support.vtech.com.au
NZ Customers:
Phone: [phone]
Website: support.vtech.com.au
PRODUCT WARRANTY/
CONSUMER GUARANTEES
UK Customers:
Read our complete warranty policy online at vtech.co.uk/warranty.
Australian Customers:
VTECH ELECTRONICS (AUSTRALIA) PTY LIMITED –
CONSUMER GUARANTEES
Under the Australian Consumer Law, a number of consumer guarantees
apply to goods and services supplied by VTech Electronics (Australia)
Pty Limited. Please refer to vtech.com.au/consumerguarantees for
further information.

TM & © 2023 VTech Holdings Limited.
All rights reserved.
IM-549500-001
Version:0
Visit our website for more
information about our products,
downloads, resources and more.
www.vtech.co.uk
www.vtech.com.au