VALCOBABY EZ Rider Installation and operation manual

Thank you for purchasing a quality VEE BEE
product. Please read and follow the instructions
outlined in this guide carefully. Familiarise yourself
with the construction and safety features; be sure
that you understand all the warnings and safety
guidelines before use.
Important: Please read the following
instructions carefully before assembling this
product. Retain this guide in a safe place for
future reference. Please refer to your pram
or pusher’s manufacturer’s instructions to
ascertain the suitability of using the EZ Rider
with your model. Some prams and strollers are
not suited to bearing additional loads and use
of the EZ Rider may void your pram or stroller’s
warranty.
PRODUCT
REFERENCE GUIDE
© Copyright VE 2012
vs290512
Due to our policy of continuous product
development, this product is constantly evolving.
It is possible that some features or procedures
outlined here have changed since this document
was written. If you are unsure of any procedure
shown here, please contact us via the web at
[email protected] to obtain the most up to date
information before use. Include the batch number,
which can be found on a sticker on the frame.
All pictures and diagrams herein are provided for
illustration purposes only.
Actual product, colour or fabric may vary.
VEE BEE reserves the right to modify or alter any
specication or colour without notice or obligation
to modify any product previously purchased
FURTHER INFORMATION
In Australia/New Zealand
veebee.com.au
EZrider
Ride on seat & Board

FOOT BOARD ASSEMBLY
Congratulations on Purchasing a VeeBee EZ Rider.
The EZ Rider will let your little ones stand - or sit with the seat
attachment inserted - behind your pram or stroller. Please read
these instructions carefully before using the EZ Rider. Incorrect
use may endanger your child.
WARNING:
• The EZ Rider is designed for use for children over 15 months of
age and a maximum weight of 25kg.
• The EZ Rider was developed for use with prams, strollers or
buggies with a rigid rear axle, or a tube or horizontal structure with
a maximum diameter of 45mm.
• In cases where there is no suitable structure readily available
to attach the EZ Rider to - or where brake function may be
compromised - the product may not be suitable. In this case,
please consult with you pram or stroller vendor.
FIGURE A - BOARD ASSEMBLY
1. Insert the M10 bolts (3) into the top of the foot board (1),
locating them into the wheels (2) and securing them with the
M10 nuts (4) beneath using the multi purpose tool provided.
FIGURE B - ATTACHING THE COUPLING ADAPTORS
2. The EZ Rider comes with three pairs of adaptors (5) enabling
it to be configured to most diameters of rear axle strollers.
These are:
• 10mm axle
• 1” [25.4mm] axle
• Other axles up to 45mm
3. Please identify the correct adaptor(5) for your pram and insert
them into the coupling arm (6) as shown below. Withdraw the
trigger and slide the chosen adaptor into the bent arch of the
coupling arm then return the trigger back into closed position,
securing the adaptor in place. Repeat for both sides.
FIGURE C - ATTACH COUPLING UNIT TO PRAM
4. The coupling unit (6+7) has already been pre-assembled by
the manufacturer, but should be loosened and re-secured
on your pram in the widest possible configuration - while
accommodating existing components (i.e. baskets, brakes,
etc)
FIGURE D - ATTACH L-BAR
5. The L-bar (9) serves to attach the foot board (1) to the coupling
unit (7) and keep it level with the pram. If the coupling unit
(7) on the pram has a clearance of less than 16 cms from
the ground, you may need to turn the L-bar (9) upside down
before securing it to the coupling (7) and the foot board (1).
A protective sleeve is provided which
will help to avoid cosmetic scratching
to your concealed brake axle.
Slip the protective sleeve over the wire
U end of the coupling prior to use
As the protective sleeve is a tight fit,
it is recommended that you lubricate
the wire U first with petroleum jelly to
ease the sleeve into place.
1
2
2
3
34
4
A
B
25.4mm 10mm 45mm
Pull & hold
Slide
6
6
7
5
C
D
7
7
8
8
9
9
L-plate in ‘up’ position
L-plate in ‘down’ position

FIGURE E -ATTACH L-BAR CONTINUED
5. The foot board (1) is supposed to sit 16 cm above the ground,
while secured by two M6 nuts (8) and M6 screws (10) to the
base of the L-bar (9)
WARNING: THE EZ RIDER MUST BE ASSEMBLED SO THAT
THE BOARD IS AS PARALLEL TO THE GROUND AS POSSIBLE.
FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY
6. Your EZ Rider should now be level, and firmly mounted in the
centre of the pram, without interfering with its use. If this
is not the case, please go over steps 1-6 again and review
instructions.
*NOTE: If the EZ Rider is being used for standing only, please
ensure the seat mounting hole is covered with the plastic lid (12)
supplied for safety.
FIGURE G- COUPLING STRAPS
7.The EZ Rider is provided with an additional pair of straps to
provide an extra secure connection to your pram. Please
connect these to the neck of the coupling arms and fasten
around the connection as shown.
FIGURE H- STORAGE STRAP
8. The EZ Rider is provided with a storage strap which allows the
EZ Rider to be stowed when not in use. To use attach the strap
to the handle bar and hook the EZ Rider firmly to the pram at
the base (12).
*NOTE: The Storage strap may not be suitable for some baby
buggies, please consult with your product vendor for more
information on specific models
FIGURE I - ATTACH SEAT
9. Remove plastic lid (13) from the foot board and mount on the
seat post (14) for storage. Insert the post at the base of the
seat into the connecting post (14), then insert this assembly
into the foot board (15) and secure from underneath with the
seat fastening bolt. (16)
10. Adjust seat to desired height and secure by inserting screws
into the appropriate and corresponding holes.
WARNING: ENSURE SEAT IS SECURELY FASTENED BEFORE USE.
G
I
1
10
15
16
14
8
7
7
8
9
9
10
1
E
H
13
12

In Australia/New Zealand
veebee.com.au
WARNING
● THE USE OF THE EZ RIDER IS ONLY RECOMMENDED IF THERE IS A CHILD IN THE PRAM BODY, OR IF THE
PRAM HANDLES ARE FIRMLY SECURED BY AN ADULT
● THE PUSHING HANDLES OF THE PRAM MUST BE HELD TIGHTLY WITH BOTH HANDS BY AN ADULT AT ALL TIMES.
● THE EZ RIDER IS NOT A TOY. NEVER LEAVE YOUR CHILD UNATTENDED.
● THE EZ RIDER MUST NOT BE USED IF YOU GO JOGGING WITH THE PRAM.
● THE EZ RIDER IS DESIGNED FOR CHILDREN UPWARDS OF 15 MONTHS AND UP TO A MAXIMUM WEIGHT OF
25 KG. IN ORDER TO GUARANTEE THE SAFETY AND FUNCTIONALITY OF THE DEVICE, AVOID ANY OVERLOADING AND
UNDER NO CIRCUMSTANCES USE IT FOR TRANSPORTING OTHER ITEMS.
● NEVER USE THE THE EZ RIDER WITH A CHILD ON IT WHILE CROSSING ANY ROAD
Remember, your child’s safety is your responsibility...
●NEVERUSEONSTAIRSORESCALATORS.
●ALWAYSUSETHETETHERSTRAPWHENTHESTROLLERISINUSE.
●THECORRECTUSEANDMAINTENANCEOFTHISVEHICLEAREESSENTIAL.
●BESURETHATALLCLAMPSANDBUCKLESARESECURELYFIXEDANDINPLACEBEFOREUSE
●WHENINTHESTROLLER,YOURCHILDMUSTALWAYSWEARTHESAFETYHARNESS,CORRECTLYFITTEDANDADJUSTED,AT
 ALLTIMES.
●DONOTUSETHEEZRIDERUNTILYOURCHILDCANWALKINDEPENDENTLYANDWITHOUTHELP.CHILDREN  
 MUSTONLYBETRANSPORTEDONTHEFOOT-BOARDINASTANDINGPOSITION.
●ALLOWYOURCHILDTOALIGHTFROMTHEEZRIDERBEFOREREACHINGPAVEMENTEDGES,STAIRS,STEEP  
 PATHS,TIGHTCORNERS,ASWELLASWHENMANOEUVRINGBACKWARDS.
●THEREMAYBEPRAMS,STROLLERSANDBUGGIESWHICHARENOTSUITABLEFORUSEWITHTHEEZRIDER,
 ASTHEYCANNOTPROVIDEASECURECONNECTINGSTRUCTUREFORLATCHINGTHEEZRIDERONTO.PLEASECONSULTWITH
 YOURPRODUCTVENDORFORMOREINFORMATION.
●BEFORESTARTINGOUTONEACHJOURNEY,CHECKWHETHERBOARDANDPRAMARECORRECTLYCONNECTEDTOONE 
 ANOTHERANDPARALLELTOTHEGROUND.
●ALWAYSCHECKTHATALLSCREWSANDMOUNTINGSOFTHEEZRIDERARESITTINGFIRMLYAND  
 THATALLPARTSOFTHEPRAMAREOKBEFOREUSE.
●ANYALTERATIONSTOTHEEZRIDERMAYCAUSETHEPRODUCTTOMALFUNCTIONANDRENDERITUNSAFE.
 ITWILLALSOVOIDANYWARRANTIES.
●INTHEEVENTOFDAMAGETOANYCOMPONENTOFTHEEZRIDERDISCONTINUEUSEIMMEDIATELY.ONLYUSE 
 ORIGINALREPLACEMENTPARTSPROVIDEDBYTHEMANUFACTURER.
●THEEZRIDERISNOTSUITABLEFORSNOWY,ICYORSOFTSURFACES.
●CLEANTHEBOARDANDTHEWHEELSFROMTIMETOTIMEWITHWARMSOAPYWATER.
●PLEASEKEEPTHEPLASTICPACKINGAWAYFROMCHILDRENORDISPOSEOFITASTHEREISARISKOFSUFFOCATION.
●KEEPTHEINSTRUCTIONMANUALCAREFULLYFORANYPOSSIBLESUBSEQUENTUSERS.
●APARTFROMTHESEINSTRUCTIONS,PLEASEREFERTOANYINSTRUCTIONSYOUHAVERECEIVEDFROMYOURPRAM 
 MANUFACTURER.
●THISPRODUCTISINTENDEDFORDOMESTICUSEONLY.ITISNOTINTENDEDFORCOMMERCIALUSE.
●PLEASEREFERTOYOURPRAMORPUSHER’SMANUFACTURER’SINSTRUCTIONSTOASCERTAINTHESUITABILITYOFUSING
 THEEZRIDERWITHYOURMODEL.SOMEPRAMSANDSTROLLERSARENOTSUITEDTOBEARINGADDITIONALLOADSAND
 USEOFTHEEZRIDERMAYVOIDYOURPRAMORSTROLLER’SWARRANTY.