VALCOBABY VEE BEE LIO Installation and operation manual

PAGE 1
by valco baby
LIO
Stroller
© Copyright VB 2014
vs111214
PRODUCT REFERENCE GUIDE
Thank you for purchasing a quality VEE BEE product.
Please read and follow the instructions outlined in this
guide carefully. Familiarise yourself with the construction
and safety features; be sure that you understand all the
warnings and safety guidelines before use.
Important: Please read the following instructions
carefully before assembling this product. Retain this
guide in a safe place for future reference.
Due to our policy of continuous product development,
this product is constantly evolving. It is possible that
some features or procedures outlined here have changed
since this document was written. If you are unsure of
any procedure shown here, please contact us via the
web at [e-mail] to obtain the most up to date
information before use. Include the batch number, which
can be found on a sticker on the frame.
All pictures and diagrams herein are provided for
illustration purposes only. Actual product, colour or fabric
may vary. VALCO BABY reserves the right to modify or alter
any specication or colour without notice or obligation to
modify any product previously purchased
FURTHER INFORMATION
In Australia/New Zealand
www.veebee.com.au
DISCLAIMER
1>PARTS LIST
1 x Hood with Sun Cap
2x front
Wheels
Stroller frame
& seat
LIO IM_020818.indd 1 2/8/18 3:22 pm

PAGE 2
2>ASSEMBLY
3>FRONT WHEELS
LIO IM_020818.indd 2 2/8/18 3:22 pm

PAGE 3
4>BRAKES 5>HOOD
NOTE: THE REAR WHEELS
ARE PRE-INSTALLED AND
COME ATTACHED TO YOUR
STROLLER
LIO IM_020818.indd 3 2/8/18 3:22 pm

PAGE 4
6>FOLDING
8>SEAT RECLINE 9>FOOTREST
ALWAYS ENGAGE THE FRAME LOCK WHEN FOLDED. TAKE CARE WHEN LIFTING THE
VEHICLE TO KEEP YOUR KNEES BENT AND BACK STRAIGHT. DO NOT CARRY THE
VEHICLE BY THE HOOD OR THE REAR BRAKE AXLE. ALWAYS USE THECARRY HANDLE
a
b
a
a
a
b
c
LIO IM_020818.indd 4 2/8/18 3:22 pm

PAGE 5
10>HARNESS
‘CLICK’
‘PRESS’
aCb
d
e
ALWAYS USE THE
RESTRAINT SYSTEM
LIO IM_020818.indd 5 2/8/18 3:22 pm

PAGE 6
11>TETHER STRAP
WARNING: USE THIS STRAP TO STOP THE PRAM/STROLLER ROLLING AWAY
1>PARTS LIST
1x hood, 2x rear wheels, 2x front wheels,
stroller frame/seat.
2>TO OPEN
Remove the carton contents carefully.
Dispose of any packaging materials
thoughtfully.
Release the stroller from the locked
position by lifting the locking hinge from
over the locking rivet on the stroller frame.
HINT: You may have to squeeze the stroller
legs and handles closer together first so as
to release the tension on the rivet.
Standing behind the stroller and holding
it by the handles, allow the wheels to fall
forward.
With your foot, press down on the primary
locking hinge until the entire frame locks
into the open position.
IMPORTANT WARNING: ALWAYS
TEST THAT ALL LATCHES ARE
SECURELY ENGAGED BEFORE USE.
3>FRONT WHEELS
Insert the front swivel wheel over the housing
on the front leg. Be sure that the swivel lock at
the top of the housing is correctly orientated.
Repeat for the other wheel.
To fix the front wheels in the non swivel
position, turn the wheel so that the two
notches on both housings line up at the
front.
Lift the swivel lock until it locks into place.
To unlock, press down firmly on the swivel
lock to release.
IMPORTANT WARNING: ALWAYS
TEST
THAT WHEELS ARE SECURELY
LOCKED
IN PLACE BEFORE USE. IF YOUR
SWIVEL WHEELS ARE NOT PERFORMING
CORRECTLY, CHECK TO SEE THAT THE
WHEEL WAS CORRECTLY INSERTED IN
THE DIRECTION OF THE ARROW.
5>BRAKES
To activate the brake press down on each
brake lever until it engages in the brake
cog on the wheel.
To release, lift each brake lever in turn.
WARNING: ALWAYS engage BOTH WHEEL
BRAKES when the stroller is at rest.
6>HOOD
Clip the hood clip onto the frame just
above the folding hinge (a). Fasten the
hood Velcro straps around the top of the
frame (b).
Repeat for the other side.
INSTRUCTIONS
LIO IM_020818.indd 6 2/8/18 3:22 pm

PAGE 7
www.veebee.com.au
Arrange the rear hood skirt beneath and
around the seat back and secure the snaps
to the corresponding snaps found on the
back of the seat.
To use the extra hood coverage, simply pull
the hood extension forward to the desired
position. To retract, reverse the process.
7>FOLDING
Lift the primary safety lock (a) with your
foot. Press down on the secondary lock (b)
with your foot.
Simultaneously push the handles all the
way down to meet the wheels.
When pushed down fully, the frame lock
should automatically engage. (c)
ALWAYS ENGAGE THE FRAME LOCK
WHEN FOLDED. TAKE CARE WHEN
LIFTING THE VEHICLE TO KEEP YOUR
KNEES BENT AND BACK STRAIGHT. DO
NOT CARRY THE VEHICLE BY THE HOOD
OR THE REAR BRAKE AXLE. ALWAYS USE
THECARRY HANDLE
8>HARNESS
Your stroller harness is specifically
designed with many built in safety features.
This includes the requirement that, when
opened, all straps are released so that no
dangerous loops can be formed causing a
strangulation hazard.
WARNING: YOUR CHILD MUST
ALWAYS BE HARNESSED WHEN IN
THE STROLLER
Closing your harness: Slide each of the
shoulder strap bottom guides (a) into the
corresponding channel on the top of each
side strap prong. Insert each completed
prong into the central buckle housing (b).
Carefully adjust the harness straps to snugly
fit your child by adjusting the sliders (c)
located on each strap. The harness should
be fitted to your child’s body, tight enough
so that they cannot wriggle free of the straps
but, loose enough, so as not to cause any
discomfort.
For even more flexibility, the height at
which your shoulder straps are fitted to the
stroller can be adjusted at 3 points(d).
To change the shoulder strap position:
Open the harness. Rethread the shoulder
strap strap back through the desired loop
on the front of the seat
Opening your harness: Press the central
housing button (e). This will release both
side prongs from the central housing.
The shoulder and waist straps will release
automatically from each other.
If the shoulder and waist straps do not
automatically disengage from each other,
manually slide the guides of the waist
channels. Your harness will separate into
5 sections.
IMPORTANT WARNING: WHEN NOT
IN USE, BE SURE THE SHOULDER
AND WAIST STRAPS ARE ALWAYS
DISCONNECTED FROM THE CENTRAL
HOUSING AND EACH OTHER
9>SEAT RECLINE
To raise the seat, gently push the seat
forward into the desired position.
To recline the seat, simultaneously push
both seat recline levers (a) and ease the
seat back to the desired position.
NOTE: ALWAYS TEST THAT THE
SEAT IS SECURELY FIXED IN
POSITION BEFORE USE. SPECIAL CARE
MUST BE TAKEN WHEN ADJUSTING THE
SEAT POSITION WITH A CHILD IN THE
STROLLER.
10>FOOTREST
To adjust your footrest downward, press
on each side adjuster while simultaneously
pressing down lightly on the footrest.
FOR SAFETY, YOUR FOOTREST IS
DESIGNED TO COLLAPSE IF EXCESS
WEIGHT IS APPLIED TO IT.
11>TETHER STRAP
WARNING: USE THIS STRAP TO
STOP THE PRAM/STROLLER
ROLLING AWAY.
LIO IM_020818.indd 7 2/8/18 3:22 pm

PAGE 8
FURTHER INFORMATION:
veebee.com.au
Find us on:
WARNING: TO AVOID INJURY OR DEATH
• FOLLOW THE MANUFACTURER’S INSTRUCTIONS.
• ALWAYS APPLY THE BRAKES WHENEVER THE PRAM/STROLLER* IS STATIONARY.
• DO NOT LEAVE CHILDREN UNATTENDED.
• DO NOT CARRY EXTRA CHILDREN OR BAGS ON THIS PRAM/STROLLER*.
• MAKE SURE CHILDREN ARE CLEAR OF ANY MOVING PARTS IF YOU ADJUST THE PRAM/
STROLLER*, OTHERWISE THEY MAY BE INJURED.
• SECURE THE CHILD IN THE HARNESS AT ALL TIMES.
• WHEN NOT IN USE DISCONNECT SHOULDER STRAPS FROM THE WAIST
STRAP AND/OR BUCKLE.
REMEMBER, YOUR CHILD’S SAFETY IS YOUR RESPONSIBILITY...
•NEVER USE ON STAIRS OR ESCALATORS.
• ALWAYS USE THE TETHER STRAP WHEN THE STROLLER IS IN USE.
• THE CORRECT USE AND MAINTENANCE OF THIS VEHICLE ARE ESSENTIAL.
• BE SURE THAT ALL CLAMPS AND BUCKLES ARE SECURELY FIXED AND IN PLACE BEFORE USE
• USE THIS HARNESS AT ALL TIMES. ALWAYS USE THE HARNESS, CORRECTLY
FITTED AND ADJUSTED, WITH YOUR CHILD IN THIS SEAT.
• THE MAXIMUM WEIGHT OF THE CHILD FOR WHICH THIS STROLLER WAS INTENDED
IS 18KGS (39LBS).
• THE MAXIMUM HEIGHT OF THE CHILD FOR WHICH THIS STROLLER WAS INTENDED IS 90CM (35INCHES).
• THE STROLLER MAY BECOME UNSTABLE IF THE MANUFACTURER’S RECOMMENDED LOAD IS EXCEEDED.
• CARE MUST BE TAKEN WHEN FOLDING AND UNFOLDING THE PRODUCT TO PREVENT
FINGER ENTRAPMENT.
• NEVER RUN WITH A NEWBORN BABY IN ANY PRAM OR STROLLER UNTIL THE CHILD CAN SIT UP
UNASSISTED (APPROXIMATELY 6 MONTHS).
• CHECK ALL PARTS BEFORE USE FOR BREAKAGE OR FATIGUE. DISCONTINUE USE IMMEDIATELY
IF ANY PART IS FOUND TO BE DAMAGED OR BROKEN.
• MAXIMUM LOAD OF BASKETS: 3.5KGS (7.5LBS).
•
DO NOT CARRY ADDITIONAL CHILDREN. THIS STROLLER IS MANUFACTURED FOR USE WITH ONE CHILD ONLY
• ALWAYS BE AWARE OF THE RISKS PROVIDED BY FIRE AND OTHER SIGNIFICANT SOURCES OF HEAT
SUCH AS RADIATORS, ETC. WHICH MAY BE IN THE IMMEDIATE VICINITY OF YOUR STROLLER.
• IT MAY BE UNSAFE TO USE ANY ACCESSORIES OTHER THAN VALCO BABY APPROVED ONES.
• THIS PRODUCT IS INTENDED FOR DOMESTIC USE ONLY. IT IS NOT INTENDED FOR COMMERCIAL USE.
• THIS STROLLER IS DESIGNED FOR USE ON FLAT OR GENTLY SLOPING SURFACES AND MAY BECOME
UNSTABLE OR TIP OVER IF USED ON HIGH SLOPING OR UNEVEN SURFACES.
• ALWAYS ENGAGE THE FRAME LOCK WHEN FOLDED. TAKE CARE WHEN LIFTING THE VEHICLE TO KEEP
YOUR KNEES BENT AND BACK STRAIGHT. DO NOT CARRY THE VEHICLE BY THE HOOD OR THE REAR
BRAKE AXLE. ALWAYS USE THE CARRY HANDLE.
Should the chassis become wet, dry off promptly before storing. If this pram is used near the ocean or salted roads, spray the chassis and seat frame
with water and dry. We recommend a rust inhibiting product should be used to prevent rust and fatigue on metal parts. We recommend that you wipe
down axles and lubricate the wheels every 3 months. Sand and dirt can grind down axles, if you live near the beach or in a dusty environment you must
wipe down the axles and wheels then lubricate them monthly.
AXLES ARE BEST LUBRICATED WITH GREASE OR PETROLEUM JELLY. MOVING PARTS ARE BEST LUBRICATED WITH SILICONE BASED PRODUCTS.
DO NOT USE OIL BASED PRODUCTS.
WARNING
WARNING
LIO IM_020818.indd 8 2/8/18 3:22 pm