VALCOBABY zee two Installation and operation manual

© Copyright
VE 2013
vs190813USA
FURTHER INFORMATION:
valcobaby.com
Find us on:
ZEE TWO
Stroller
PRODUCT REFERENCE GUIDE

Due to our policy of continuous product development,
this product is constantly evolving. It is possible that
some features or procedures outlined here have
changed since this document was written. If you are
unsure of any procedure shown here, please contact
us via the web at [email protected] to obtain the
most up to date information before use. Include the
batch number and model number, which can be found
on a sticker on the frame.
All pictures and diagrams herein are provided for illustration
purposes only.
Actual product, colour or fabric may vary.
VALCO BABY reserves the right to modify or alter any
specification or colour without notice or obligation to
modify any product previously purchased
ZEE TWO
Stroller
Thank you for purchasing a quality
VALCO BABY product.
Please read and follow the instructions
outlined in this guide carefully. Familiarise
yourself with the construction and safety
features; be sure that you understand all
the warnings and safety
guidelines before use.
Important: Please read the following
instructions carefully before
assembling this product. Retain
this guide in a safe place for future
reference.
DISCLAIMER

2 x HOODS
BASKET
2 x FRONT WHEELS
2 x REAR WHEELS
BRAKE
2 x AXELS
SEATSEAT 2 x BUMPER BAR
a
c
b
e
f
d
2>TO OPEN
1>PARTS LIST
3>REAR AXLE
4>BASKET

↑
↑
SQUEEZE PULL
5>REAR WHEELS
7>BUMPER BAR 8>FOOTREST
10>BRAKES
9>SEAT RECLINE
6>FRONT WHEELS
h
i
j
k
n
o p q
g
l
m

Fixture 1
Fixture 2
12>HARNESS
11>HOOD
13>FOLDING
s
r
y
z
HOOD SKIRT
SEAT SIDE
PUSH
PRESS
DOWN
HOLD
DOWN RELEASE
HOLD
CLICK
bc
df e
a
PUSH
PRESS
DOWN
HOLD
DOWN RELEASE
HOLD
CLICK

1>PARTS LIST
Remove the stroller from the carton and
dispose of all packaging thoughtfully. Check
contents: 2x hood, 2x bumper bar, 1x basket,
2x front wheels, 2x rear wheels, 2x axels, 1x
brake, 1x seat.
2>TO OPEN
Release frame lock on side of stroller frame (a).
Lift the stroller handle upward and over in
one contiuous motion until the lower chassis
locks into position (b). (You should hear an
audible ‘click’).
IMPORTANT WARNING: ALWAYS TEST
THAT ALL LATCHES ARE SECURELY
ENGAGED BEFORE USE.
3>REAR AXLE
Align the plastic housings of the rear brake
section with the open tubes of the rear of the
stroller chassis (c) .
IMPORTANT WARNING : BE SURE THAT
THE RED BRAKE LEVER IS UPRIGHT
Insert the housings over the open tubes until
the brake section locks securely into place.
IMPORTANT WARNING: TEST THAT THE
BRAKE SECTION IS SECURELY ENGAGED
ONTO THE STROLLER FRAME BY PULLING
ON IT FIRMLY.
4>BASKET
Align the basket frame with the open tubes at
the rear of the seat. Simultaneously pressing
in the locking buttons (d), slide the basket
frame into the housing until the buttons lock
into place.
Basket front - pass the front flap over the
bar between the seat and the seat frame (e).
Secure with the snaps. Pull the side flaps
around the front and Velcro into place on the
front flap (f).
5>REAR WHEELS
Simultaneously press on the spring loaded
axle button (g) and insert it through the
central hub of the rear wheel. Repeat this
process for the other rear wheel.
Pressing the axle button again (h), insert the
axle end into the side of the brake housing
as far as it will go. Release the axle button
and pull slightly on the wheel to ensure that
it has securely engaged.
6>FRONT WHEELS
Grasping the front wheel, align the shaft with
the hole in the underside of the swivel housing
(i). Depress the button on the top of the swivel
housing (j). Insert the shaft into the housing as
far as it can go until it engages securely.
Repeat the procedure for the other front wheel.
IMPORTANT: Pull the wheel downward to test
THAT IT HAS SECURELY ENGAGED IN THE
HOUSING.
Locking your wheels: Your front wheels can
be set to swivel freely (360º) or can be fixed
in place for use over rough or sandy surfaces.
To fix the front wheel in the non swivel position,
turn the wheel so that the two notches on both
housings line up. Press down firmly on the
swivel lock until it locks into place (k).
To unlock simply lift the locking tab until it locks
in the open position
.
7>BUMPER BAR
Insert the front bar ends into the nylon housings
located on either side of the frame. Be sure that
the bar is securely engaged.
Adjust the front bar by simultaneously pressing
the button on the bar housing and swivelling
the bar to the uppermost position (l). This is the
only position for use with a child in the stroller.
To remove the front bar: Feeling the side of
the nylon housing that sits below the frame at
each side (facing inward), locate the release
button (m). Press each release button inward
while simultaneously pulling upward on the bar
housing. Repeat for the other side. Note that
this may be difficult to do as the bar is secured
firmly as a safety precaution.
IMPORTANT WARNING: THE FRONT
BAR IS NEITHER A RESTRAINING NOR
CARRYING DEVICE.
8>FOOTREST
To adjust your foot rest downward, press the
central buttons on either side of the footrest
while simultaneously adjusting it up or down(n).
IMPORTANT WARNING: YOUR FOOTREST
IS DESIGNED TO COLLAPSE IF EXCESS
WEIGHT IS APPLIED TO IT
9>SEAT RECLINE
To recline: While squeezing the seat adjuster
tabs (o) together in a pincer like movement,
ease the seat down to the desired
position. Release the tabs and the seat will
INSTRUCTIONS

automatically lock in that position
To incline: Place your hand in the centre of
the seat at the rear.
Pull the incline strap (p) while gently pushing
the seat upward to the desired position.
10>BRAKE
To engage the brake press down on the
central red brake pedal (q), until the brakes
engage fully into the wheel cogs.
To disengage, simply reverse the process.
11>EXPANDA HOOD
The Expanda hood unzips, increasing the
size of your standard hood to give greater
coverage and protection from the sun and
weather for your child.
To open the Expanda Hood: Locate the zip
in the center of the Expanda Hood and unzip
completely (r). Gently pull the Expanda Hood
forward until it is reaches its full extension.
To close the Expanda Hood: Gently push the
Expanda Hood back, allowing the middle
section to fold in on itself. Carefully zip the
Expanda Hood closed.
The hood offers two height positions to
allow for your child’s growth (s). To increase
the height of the hood simply move the hood
to the second fixture.
IMPORTANT HOOD INSTALLATION
INSTRUCTION
Secure the rear hood skirt to the frame by
passing the press stud through the slot
provided and firmly engaging the other half
by pressing strongly. Always test that the
press studs are fully and firmly engaged.
12>HARNESS
To secure your child in the harness:
Overlap buckles and so that they fit together
to form one complete buckle (a).
Insert the completed buckle into the Buckle
Housing (b) until it engages securely in
place(c).
To open your harness:
Push down on both Buckle Prongs (d).
Simultaneously press the release button in
the centre of the buckle (e).
Lift the buckles from the Buckle Housing (f).
IMPORTANT WARNING:
AVOID SERIOUS INJURY FROM FALLING
OR SLIDING OUT. ALWAYS USE SEAT BELT
13>FOLDING
To ensure maximum compactness, prior to
folding your stroller:
•fold the hood closed back against the
handle
•incline the seat
•lower the bumper bar
•remove all contents from the basket
Locate the frame release (y) on either side
of the handle. Lift the frame release buttons
on either side of the handle simultaneously
upwards.
Swing the handle forward. As the handle
passes the fold joint (z), you will feel the
lower chassis release and fold downward in
a ‘z’ shape.
Push the frame down completely until the
frame lock engages.

FURTHER INFORMATION:
valcobaby.com
Find us on:
WARNING: To AvoId INjuRy oR deATh
• always apply the brakes whenever the pram/stroller is stationary
• Do not leave ChilDren UnattenDeD.
• seCUre the ChilD in the harness at all times.
• Do not Carry eXtra ChilDren or baGs on this pram/stroller.
• make sUre ChilDren are Clear oF any movinG parts iF yoU aDJUst the pram/
stroller. otherwise they may be inJUreD.
! warninG: Use this harness at all times.
! warninG: when not in Use DisConneCt shoUlDer straps From the waist strap anD/
or bUCkle.
• Follow the manUFaCtUrer’s instrUCtions.
Remember, your child’s safety is your responsibility...
•NeveR uSe oN STAIRS oR eSCALAToRS.
• AlwAys use the tether strAp when the stroller is in use.
• the CorreCt use AnD MAintenAnCe oF this VehiCle Are essentiAl.
• Be sure thAt All ClAMps AnD BuCkles Are seCurely FixeD AnD in plACe BeFore use
• when in the stroller, your ChilD Must AlwAys weAr the sAFety hArness, CorreCtly
FitteD AnD ADjusteD, At All tiMes.
• AlwAys use the hArnesses, CorreCtly FitteD AnD ADjusteD, with eACh ChilD in his seAt.
• the MAxiMuM weight oF the ChilD For eACh seAt whiCh this stroller wAs intenDeD is
20kgs (44lBs).
• the MAxiMuM height oF the ChilD For whiCh this stroller wAs intenDeD is 90CM
(35inChes).
• the stroller will BeCoMe unstABle iF the MAnuFAturer’s reCoMMenDeD loAD is
exCeeDeD.
• CAre Must Be tAken when FolDing AnD unFolDing the proDuCt to preVent Finger
entrApMent.
• CAn Be useD FroM A newBorn BABy onwArDs. A CoCoon, speCiAlly DesigneD to Be useD
with A stroller, is reCoMMenDeD when Any Fully reClining stroller is useD with A
newBorn.
• neVer run with A newBorn BABy in Any prAM or stroller until the ChilD CAn sit up
unAssisteD (ApproxiMAtely 6 Months).
• CheCk All pArts BeFore use For BreAkAge or FAtigue. DisContinue use iMMeDiAtely iF
Any pArt is FounD to Be DAMAgeD or Broken.
• MAxiMuM loAD oF BAskets: 5kgs.
• Do not CArry ADDitionAl ChilDren. this stroller is MAnuFACtureD For the use with
TWo ChILdReN oNLy
• AlwAys Be AwAre oF the risks proViDeD By Fire AnD other signiFiCAnt sourCes oF heAt
suCh As rADiAtors, etC. whiCh MAy Be in the iMMeDiAte ViCinity oF your stroller.
• it MAy Be unsAFe to use Any ACCessories other thAn VAlCo BABy ApproVeD ones.
• this proDuCt is intenDeD For DoMestiC use only. it is not intenDeD For CoMMerCiAl use.
Should the chassis become wet, dry off promptly before storing. If this pram is used near the ocean or salted
roads, spray the chassis and seat frame with water and dry. We recommend a rust inhibiting product should be
used to prevent rust and fatigue on metal parts.
We recommend that you wipe down axles and lubricate the wheels every 3 months. Sand and dirt can grind
down axles, if you live near the beach or in a dusty environment you must wipe down the axles and wheels then
lubricate them monthly.
AXLES ARE BEST LUBRICATED WITH GREASE OR PETROLEUM JELLY. MOVING PARTS ARE BEST LUBRICATED
WITH SILICONE BASED PRODUCTS. DO NOT USE OIL BASED PRODUCTS.