OPERATING MANUAL 3300 HSDR V4.4/20-EN
Page | 4
•Do not bring compressed air and/or medium into contact with
skin or eyes.
•Never direct the spray jet at animals, people or yourself.
•Keep children and pets away from the operating area.
•No manipulations, emergency repairs or misappropriations
may be carried out on the pressure cup gun.
•Pressure cup guns may only be operated and maintained by
instructed persons.
•Repairs must only be carried out by qualified persons.
The following applies to all maintenance and repair work:
•It is essential to disconnect the pressure cup gun from the
compressed air connection before carrying out maintenance
or repair work.
•Only use original spare parts.
•The maximum working pressure must not be exceeded (see
point 1 "Technical data"). The working pressure must be
adjusted via a (filter) pressure reducer.
•Only use compressed air as energy source.
•The compressed air connection may only be made via a quick
coupling.
•When working with the pressure cup gun, wear the necessary
protective clothing, protective goggles, work gloves, ear pro-
tection if necessary and a respirator mask.
•If there are leaks in the device or other operating faults, the
device must be disconnected from the compressed air supply
immediately and the cause of the fault must be eliminated.
•Open fire, sparks or smoking is prohibited.
•Beware of flammable materials.
•Processed media and cleaning media must be disposed of in
an environmentally friendly manner.
•The disposal of the compressed air device must be carried out
according to the valid legal regulations.
6. Installation/ end of work
Preparing the gun for the first start-up: Screw in the compressed air connection
and tighten it firmly using a 13 mm open-end wrench or ring spanner, if
necessary glue it in place.
With optional pressure regulator instead of air volume regulation: Screw the
pressure gauge included in the extent of delivery into the pressure regulator, if
necessary glue it in.
Start-up: Unscrew the pressure container and fill the medium into the con-
tainer. Then hand-tighten the gun with the container cover onto the pressure
container. Do not use any tools for this! Plug the connecting nipple of the hose
