Velocity VOH9 CPVELHSWH User manual

MANUFACTURER CODE: VOH9
OW CODES: CPVELHSWH, CPVELH90BW,
CPVELHSGR, CPVELH90WI
Assembly Instructions
Velocity Hutch
900 Wide
2 CARTONS
1 / 5
manufactured by designtec
www.designtec.com.au

NOTE
Please check you have all hardware before assembling.
If you are missing any hardware, please contact the store of purchase.
Please ensure you have the name of the item, required hardware part and quantity.
Please retain your receipt as proof of purchase to validate your warranty.
CAUTION
Do not tighten screws before all screws are in the right place.
Do not use this product unless all bolts, screw and knobs are firmly secured.
Check that all bolt, screws and knobs are securely tightened at least every 4 months.
WARNING
If parts are missing, broken, damaged or worn stop using the product until all repairs
are made using manufacturer authorised parts.
Failure to follow these warnings could result in serious injury.
B - PIN
x 12
x 4
A - ARRET
HARDWARE INCLUDED
Note - Individual hardware images are not to scale.
C -32mm SCREW
x 4
PRE-INSERTED HARDWARE
CAM HOUSING
TOOLS REQUIRED FOR ASSEMBLY
1 x Philips Head Screwdriver
2 / 5
D - SHELF SUPPORT
x 8

3 / 5
STEP 1
Fix eight (8) PINS (B) into the outer pre-drilled holes on your back panel with your
screwdriver.
NOTE: these pre-drilled holes are slightly offset to the edge.
BACK PANEL
(B)
(B)
(A)
STEP 2
Fix four (4) PINS (B) into the outer pre-drilled holes at the tops of your end panels as
shown
Knock in your ARRERTS (A) into the pre-drilled holes on the inside of your end panels.
RH END
LH END

4 / 5
(C)
STEP 4
Place the assembled unit to its required position and insert SCREWS (C) into the top
of your ARRET (A) and drive into top with force using your screw driver
NOTE: Be careful not to over tighten.
STEP 3
Align the CAM HOUSING on your end panels with your PINS (B) on your back panel.
Tighten by rotating the screw to the RH. Repeat this step with your top panel.
CAM HOUSING
LH END
RH END
BACK PANEL
TOP PANEL
(A)

5 / 5
STEP 5
To insert shelves, place your SHELF
SUPPORTS (D) in the holes on the
end panels at the desired shelf
height and the shelf sits on top
(D)