Velocity VRT9X User manual

MANUFACTURER CODE: VRT9X
OW CODES: CPVELRT90B, CPVELRTGR, CPVELRTWH,
CPVELRT90W
Assembly Instructions
Velocity Round Table
1 CARTON
1 / 5
manufactured by designtec
www.designtec.com.au

NOTE
Please check you have all hardware before assembling.
If you are missing any hardware, please contact the store of purchase.
Please ensure you have the name of the item, required hardware part and quantity.
Please retain your receipt as proof of purchase to validate your warranty.
CAUTION
Do not tighten screws before all screws are in the right place.
Do not use this product unless all bolts, screw and knobs are firmly secured.
Check that all bolts, screws and knobs are securely tightened at least every 4 months.
WARNING
If parts are missing, broken, damaged or worn stop using the product until all repairs
are made using manufacturer authorised parts.
Failure to follow these warnings could result in serious injury.
B - PIN
x 6
x 4
A - ADJUSTABLE FOOT
PRE-INSERTED HARDWARE
CAM HOUSING
TOOLS REQUIRED FOR ASSEMBLY
1 x Philips Head Screwdriver
HARDWARE INCLUDED
Note - Individual hardware images are not to scale.
C - CONFIRMAT SCREW
x 2
2 / 5

STEP 1
Take one HALF LEG panel and align the central pre-drilled hole with the pre-drilled
holes on the FULL LEG. Insert two (2) CONRIFMAT SCREWS (C) through the face of
FULL LEG and tighten with your screwdriver until the HALF LEG panel is secure.
STEP 2
Insert two (2) PINS (B) into the
offset pre-drilled holes with
your screwdriver.
(C)
(C)
3 / 5
(B)
(B)
FULL LEG
HALF LEG
HALF LEG

STEP 3
Align PINS (B) with the
pre-inserted CAM
HOUSING on the full leg.
Tighten CAM HOUSING
by rotating the screw to
the right hand side with
your screwdriver.
Forming your table base.
4 / 5
STEP 4
Insert four (4) PINS (B) into pre-drilled
holes as shown on drawing.
(B)
CAM HOUSING
FULL LEG
HALF LEG
HALF LEG

CAM HOUSING
STEP 5
Rotate base around and align the PINS (B) with pre-inserted CAM HOUSING on the
underside of the top. Tighten by rotating the cam screw to right hand side with your
screw driver. Then insert four (4) ADJUSTABLE FOOT (A) into pre-inserted threaded
sleeve on base. Once complete turn table upside down so it is now upright.
5 / 5
TIP: Feet can be adjusted to level the table on un-even floor.
(A)
TOP
(B)
CAM HOUSING
(B)