Velocity Workstation User manual

WORKSTATION
1800L X 1800L X 750D X 720H
1
Hardware Enclosed:
Manufacturing Company Only
x7x35
2
x2 x16
34
Note: Hardware is distributed over 3 boxes
CAM PRE-INSERTED INTO
BOARD

1
2
LH RETURN

ALIGN SIDE (A) WITH MODESTY (B), PUSH TOGETHER AND TIGHTEN TIGHTENING SCREW IN CAMS
ENSURING THAT THE HOLE S ON THE SIDE (A) OF THE MODESTY (B) ARE FACING INWARDS
ALIGN TOP (C) WITH ASSEMBLED SIDE (A) AND MODESTY (B), PUSH TOGETHER AND TIGHTEN TIGHTENING SCREW IN CAMS
PLACE ITEM (3) OVER TOP AND USE 4 X ITEM (4) TO SECURE TO TOP (C)
34

1
2
RH RETURN

ALIGN SIDE (A) WITH MODESTY (B), PUSH TOGETHER AND TIGHTEN TIGHTENING SCREW IN CAMS
ENSURING THAT THE HOLE S ON THE SIDE (A) OF THE MODESTY (B) ARE FACING INWARDS
ALIGN TOP (C) WITH ASSEMBLED SIDE (A) AND MODESTY (B), PUSH TOGETHER AND TIGHTEN TIGHTENING SCREW IN CAMS
PLACE ITEM (3) OVER TOP AND USE 4 X ITEM (4) TO SECURE TO TOP (C)
3
4

W/S ASSEMBLY

ALIGN ASSEMBLED ABOVE COMPONENTS OVER THE TOP (D) ENSURING PINS LINE UP WITH CAMS
PUSH IN PLACE AND TIGHTEN TIGHTENING SCREW UNTIL SECURE
SCREW ITEM 2 INTO PRE-BORED ENDS FOR HEIGHT ADJUSTMENT ONCE ENTIRE WORKSTATION IS ASSEMBLED FINE
ADJUST LEVELLING FEET TO SUIT YOUR REQUIREMENTS
ALIGN SIDES (C)WITH MODESTY (A&B), PUSH IN PLACE AND TIGHTEN TIGHTENING SCREWS IN CAMS ITEM 5
ENSURING THAT THE HOLE S ON THE SIDE OF THE MODESTIES (A&B) ARE FACING INWARDS

ALIGN ASSEMBLED RETURN WITH CENTRAL WORKSTATION, PINS FACING TOWARDS CIRCULAR CAMS, PUSH IN PLACE AND
TIGHTEN TIGHTENING SCREW UNTIL SECURE. HIGHLIGHTED IN CIRCLES
USE 4 X ITEM 4 AND FASTEN SECURELY TO THE LOCATING HOLES ON THE ON THE CENTRAL PORTION OF THE WORKSTATION
PLACE WORKSTATION IN CORRECT POSITION AND LEVEL AS REQUIRED USING ADJUSTABLE FEET ON ALL LEGS