Vertiv Avocent LV 5000 Series User manual

AVOCENT® HMX AND LONGVIEW™
HIGH PERFORMANCE KVM EXTENDER SYSTEMS
Rack Mount Quick Installation Guide
590-1514-501A 1
The HMX high performance KVM
extender system 5000 and 6000
series and the LongView™ 5000
series transmitters and receivers can
be rack mounted individually as a
single unit, together as a “dual” unit,
or as standalone units on the rear of
a video monitor. More information on
installing your HMX or LongView™
extender system is available on the
Avocent® HMX High Performance
KVM Extender System Quick
Installation Guide or Avocent®
LongView™ High Performance KVM
Extender System Quick Installation
Guide that ships with your extenders.
CAUTION: Because HMX and
LongView extenders and their
power supplies generate heat
when in operation, do not place
them in locations where air cannot
circulate to cool the equipment.
One-third of the U space (1.5 cm)
must be allowed between rows of
extenders when mounting within a
rack chassis. Do not operate the
system in ambient temperatures
exceeding 40O Celsius or place
extenders in contact with other
equipment that has surface
temperatures exceeding that.
Mounting on the rear of a
video monitor
NOTE: For this configuration, the
monitor must adhere to the VESA
standard for mounting holes on the
rear panel.
1. Securing the brackets to
the video monitor
Place the bracket on the video
monitor rear panel and fasten in
place with the supplied screws.
2. Positioning the extender
in the bracket
With the extender front panel
facing up, slide the bottom of
the extender into the bracket.
Align the holes and fasten in
place.
Single unit rack mounting
1. Securing brackets to the
extender
Use the supplied screws to
mount the two brackets to the
sides of the unit.
2. Positioning the extender
in the rack
Slide the assembly into the rack
and fasten in place using the
appropriate rack hardware.
1
2
Mounting On A Video Monitor (HMX extender shown)
Single Unit Mounting (HMX extender shown)
1

To contact Vertiv Technical Support: visit www.VertivCo.com
© 2017 Vertiv Co. All rights reserved. Vertiv and the Vertiv logo are trademarks or registered trademarks of Vertiv Co. All other names and logos referred to are trade names,
trademarks or registered trademarks of their respective owners. While every precaution has been taken to ensure accuracy and completeness herein, Vertiv Co. assumes no
responsibility, and disclaims all liability, for damages resulting from use of this information or for any errors or omissions. Specifications are subject to change without notice.
AVOCENT® HMX AND LONGVIEW™ HIGH PERFORMANCE KVM EXTENDER SYSTEMS
Rack Mount Quick Installation Guide
2 590-1514-501A
Dual unit rack mounting
1. Securing brackets to the
extenders
On the first extender, use the
supplied screws to attach an L
bracket to the left side and a U
bracket to the right side. On the
second extender, attach the L
bracket to the right side and
the U bracket to the left side.
2. Attaching the U brackets
Slide the U brackets on each
extender together until the
holes align, then use screws to
fasten them together.
3. Positioning the extenders
in the rack
Position the extender assembly
into a 1U rack space and mount
using the appropriate rack
hardware.
Dual Unit Mounting (HMX extender shown)
3
1
2