Rev. 10/30/2017 LAD-FM, MANUAL
Copyright 2017 Vestil Manufacturing Co. Page 2 of 16
Signal Words:
This manual uses SIGNAL WORDS to indicate the likelihood of personal injuries, as well as the
probable seriousness of those injuries, if the product is misused in the ways described. Other signal words
call attention to uses of the product likely cause property damage. The signal words used appear below
along with the meaning of each word:
Identifies a hazardous situation which, if not avoided, WILL result in DEATH or
SERIOUS INJURY. Use of this signal word is limited to the most extreme situations.
Identifies a hazardous situation which, if not avoided, COULD result in DEATH or
SERIOUS INJURY.
Indicates a hazardous situation which, if not avoided, COULD result in MINOR or
MODERATE injury.
Identifies practices likely to result in product/property damage, such as operation that might
damage the product.
Hazards of use:
Vestil strives to identify foreseeable hazards associated with the use of its products. However, no
manual can address every conceivable risk.
If this product is used improperly or carelessly, the operator and/or bystanders might sustain
serious personal injuries or even be killed. ALWAYS use the product properly:
Failure to read and understand the entire manual before installing, using or servicing the product
constitutes misuse of the product. Read the manual to refresh your understanding of proper use and
maintenance procedures.
DO NOT exceed the maximum rated load.
Inspect the stairs at least once per month according to the instructions in “Inspections and
Maintenance” on p. 14-15). DO NOT use these stairs if the inspection reveals structural damage. Examples
of structural damage include: 1) broken, missing, or deformed risers (steps); 2) damaged or deformed
handrails or side rails; 3) cracked welds; 4) damaged fasteners (particularly those used to fasten the top of
the stairs to the structure or wall above), enlarged openings for bolts, pins, etc.; 5) corrosion, extreme wear,
or other condition that affects the ability of the product to support applied weight or itself; 6) damaged,
deformed or cracked jack components, especially the slide (see FIG. 5 on p. 8). Immediately tag the
stairway “Out of service” and replace each part that fails to pass inspection. DO NOT use the product until it
is restored to normal condition. ONLY use manufacturer-approved replacement parts.
DO NOT use the stairway if any unusual noise or movement is observed while weight is applied to it. If
a malfunction occurs, remove the unit from service and notify your supervisor or maintenance personnel
about the issue.
DO NOT use the stairway UNLESS it is securely fastened to the mezzanine.
DO NOT store articles on the stairs.
DO NOT remove or obscure any label. All product labels must be readable and undamaged. (see
“Labeling diagram” on p. 15).
DO NOT modify the stairs in any way. Unauthorized modifications automatically void the limited
warranty (see p. 16) and might make the table unsafe to use.
Proper installation, use, and maintenance are essential for this product to function properly.
oAlways use this product in accordance with the instructions in this manual.
oKeep the stairs clean & dry.
oPeriodically lubricate pivot points.
