Villa ADI996-09-Series User manual

STEEL
EXAM TABLE
USER GUIDE
ADI996-09-SERIES

Thank you
for your
purchase.
Viva Comfort maintains a
strong practice of ongoing
development of products and
commercial research.
We recognize that starting and maintaining a medical practice is
expensive. We’ll help make the process cost-eective and elegant.
Additionally, our team of specialists will ensure everything you
need works as eciently as possible, so you can eectively treat
your clients.

Table of Contents
2
3
4
10
11
Parts List
Hardware List
Assembly Instructions
Warranty
Notes

2
Parts List
A
Exam Base
B
Backrest (Preinstalled)
C
Paper Dispenser
D
Knockdown Frame
E
Mattress
F
Pullout Mattress
GH
Pullout Shelf (Preinstalled) Paper Cutter

3
Hardware List
Tools Needed For Assembly:
1
2
M6*20mm Screw (x15)
M6*12mm Screw (x4)
Hex Key

4
Step 1:
Step 2:
A. Remove all the packaging from the contents in the box.
a. Ensure you are working on a at, clean surface.
A. To avoid injury, press the backrest frame up with one hand before depressing the yellow handle on
the side of the frame.
B. Guide the frame up and remove the Knockdown Frame (D) and the Paper Dispenser (C).
Assembly Instructions
D
B
C

5
B
Step 3:
A. Insert the Knockdown Frame (D) by sliding it into the metal tubes of the Backrest (B), as pictured.
D

6
Step 4:
A. Remove the packaging from the mattresses and place them on a clean surface.
B. Place the Pullout Mattress (F) on the Pullout Shelf (G).
C. Insert four M6*12 mm Screws (2) through the bottom of the frame and into the Pullout Mattress (F).
a. Secure them in place utilizing the Hex Key.
4x
2
2
F
F
G
G

7
Step 5:
A. Guide your backrest down but depressing the yellow lever and guiding the frame down.
B. Take the Mattress (E) and lay it on top of the backrest.
C. Lift the kneeboard section of the frame, with part of the mattress, from the front, up on an angle, as
shown.
D. Insert six M6*20 mm Screws (1) and secure them in place using the Hex Key.
a. Completely push in the Pullout Shelf (G).
b. Lower the kneeboard section down.
6x
B
1
B
E
1
1
1
1
1
1
E
B
1
G

8
Step 6:
A. Depress the yellow handle again and raise the Backrest (B) up and lock it in a comfortable position.
B. Insert four M6*20 mm Screws (1) into the lowest part of the Backrest (B) as shown, and turn them only
halfway with the Hex Key.
a. Do not fully tighten them.
C. Insert two M6* 20 mm Screws (1) into the middle part of the Backrest (B) as shown, and turn them
only halfway with the Hex Key.
a. Do not fully tighten them.
D. Insert three M6* 20 mm Screws (1) into the upper part of the Backrest (B) as shown.
a. Secure the screws in place and then tighten the screws from substep’s B. and C.
1
B
E
1
1
B
D
1
1
1
1
1
1
1
E
9x