Vintec VWM148SBA User manual

vintec.com
User Manual
V190SG2E-BK
VWM148SBA

As the appliance contains a
ammable refrigerant, it is
essential to ensure that the
refrigerant pipes are not dam-
aged.
The quantity and type of the
refrigerant used in your appli-
ance is indicated on the rating
plate.
Standard EN378 species that
the room in which you install
your appliance must have a
volume of 1m³ per 8 g of hydro-
carbon refrigerant used in the
appliances. This is to avoid the
formation of ammable gas/air
mixtures in the room where the
appliance is located in the event
of a leak in the refrigerant circuit.
WARNING:
Keep ventilation openings in
the appliance’s cabinet or in the
built-in structure clear of obstruc-
tion.
WARNING:
Do not use other mechanical
devices or other means to ac-
celerate the defrosting process
than those recommended by the
manufacturer.
WARNING:
Do not damage the refrigerant
system.
WARNING:
Do not use electrical appli-
ances inside the refrigerated
storage compartment, unless
they are of a type recommended
by the manufacturer.
WARNING:
Do not expose the appliance to
rain.
WARNING:
This appliance may be used by
children over the age of 8 years
old and by persons with reduced
physical, sensory or mental
capabilities or by persons with
a lack of experience or knowl-
edge if they are supervised or
are instructed by a person re-
sponsible for their safety how
to use the appliance safely and
have understood the associated
hazards.
WARNING:
Children must not play with, on,
or around the appliance.
Warning
2
User Manual

WARNING:
Children must not clean the
appliance or carry out general
maintenance unless they are at
least 8 years old and are being
supervised.
WARNING:
Do not store explosives, such
as aerosol cans with ammable
propellants in the unit.
WARNING:
Danger risk of re or explosion if
ammable refrigerant are used.
To be repaired only by trained
personnel.
WARNING:
When positioning the appliance,
ensure the power cord is not
trapped or damaged.
WARNING:
Do not locate multiple portable
socket-outlets or portable power
supplies at the rear of the appli-
ance.
● Always keep the keys in a separate place
and out of reach of children.
● Before servicing or cleaning the appli-
ance, unplug the appliance from the
mains or disconnect the electrical power
supply.
●Relevant for Australia: Supply cord
tted with a plug complies with AS/NZS
3112.
● Frost formation on the interior evaporator
wall and upper parts is a natural phenom-
enon. Therefore, the appliance should
be defrosted during normal cleaning or
maintenance.
● Please note that changes to the appli-
ance construction will cancel all warranty
and product liability.
● If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent, or similarly qualied persons inor-
der to avoid a hazard.
● Do not use extension cords.
● This appliance is intended to be used
exclusively for the storage of wine
CLASS 1 LED PRODUCT
3
User Manual

The energy consumption reduces ..
1)..the lower the ambient temperature is.
2)..the warmer thermostat set point is.
3)..the lower the number and the shorter the
length of the door openings is.
Savings in energy consumption in the use
Contents
Warning ......................................................2
Savings in energy consumption in the use . 4
Before use ..................................................5
Get to know your wine cooler .....................6
Technical data .............................................7
Installation and start-up ..............................7
Installation ..................................................8
Operation and function .............................10
Defrosting, cleaning and maintenance .....12
Fault nding ..............................................13
Charcoal Filter Location & removal .........14
Warranty, spare parts and service ............15
Disposal ....................................................16
Safety instructions ....................................17
4
User Manual

On receipt, check to ensure that the ap-
pliance has not been damaged during
transport. Transport damage should be
reported to the local distributor before the
wine cooler is put to use.
Remove the packaging. Clean the inside of
the cabinet using warm water with a mild
detergent. Rinse with clean water and dry
thoroughly (see cleaning instructions). Use
a soft cloth.
If during transport the appliance has been
laid down, or if it has been stored in cold
surroundings (colder than + 5°C), it must be
allowed to stabilise in an upright position for
at least an hour before being switched on.
Before use
5
User Manual

Get to know your wine cooler
g.1
Lighting
Control panel
Charcoal lter
Wooden shelf
Sealing strip
Nameplate
Kick plate
Lock
Adjustable feet
6
User Manual

Placement
For safety and operational reasons, the ap-
pliance must not be installed outdoors.
The appliance should be placed on a level
surface in a dry, well ventilated room (max.
75% relative air humidity). In hot humid
climate areas and particularly on hot rainy
days, humidity in the ambient air can con-
dense on the cold external surfaces, glass
door or door sealing gasket strip. Espe-
cially when appliance is set at the coldest
temperature setting in a long period of time
during high humid days which is a natural
phenomenon. During monsoon season or
high humidity days,we recommend to set
temperature at warmer or at cellaring tem-
perature mode.
Or you can simply wipe o󰀨 any moisture or
water droplets with soft dry cloth, conden-
sation will disappear when humidity level
drops or temperature set to a warmer set-
ting.
Never place the appliance close to sources
of heat such as cookers or radiators, and
avoid placing it in direct sunlight.
Ambient temperature
The climate class is stated on the name-
plate. This species the optimum ambient
temperature. Wine coolers with winter posi-
tion, however, function at ambient tempera-
tures as low as 5ºC.
Installation and start-up
Technical data
xxxxxxxxxxx
xxxxxxxxxxx
xxxxx
x.xxx
xxxxxxxxxxxxxxx
Wiring and connections in power supply
systems must been all applicable (local and
national) electrical codes. Consult these
codes lengths and sizes prior to cabinet
installation.
This device complies with relevant EU
directives including Low Voltage Directive
2014/35 LVD. and Electromagnetic Com-
patibility Directive 2014/30/ Electromagnetic
Com¬patibility Directive.
The socket should be freely accessible.
Connect the appliance only to 220/240 V
/ 50Hz alternating current via a correctly
installed earthed socket.
The socket must be fused with a 10-13 A
fuse.
If the appliance is to be operated in a non-
European country, check on the rating plate
whether the indicated voltage and current
type correspond to the values of your mains
supply.
Information regarding voltage, current or
power are given on the rating plate
The power cord may be replaced by a
technician only.
The rating plate provides various techni-
cal information as well as type and serial
number.
g. 2
Climate class Optimum room
temperature
SN +10 ºC to +32 ºC
N+16 ºC to +32 ºC
ST +16 ºC to +38 ºC
T +16 ºC to +43 ºC
7
User Manual

The surface on which the appliance is to be
placed must be level. Do not use a frame or
similar.
The appliance can be installed as a free-
standing unit against a wall, built into a
closet or lined up with other appliances.
It is important that the appliance be well
ventilated and that air can circulate unhin-
dered above, below and around it.
The gures below illustrate how the neces-
sary air circulation around the appliance
can be ensured (gs 3).
g. 3 g. 5
g. 4
(g 4) A “Side by Side” kit can be ordered
Installation
8
User Manual

The distance pieces on the rear of the ap-
pliance ensure su󰀩cient air circulation. Fit
the two caps supplied with the appliance as
shown in g. 6.
g. 6
g. 7
It is important that the appliance be abso-
lutely level. It can be levelled by screwing
the adjustable feet at the front of the appli-
ance up or down (g 7).
Use a spirit level to check that the appliance
is absolutely level sideways.
Setting up
Possible door turn
It is recommended that you use a techni-
cian for reversing the swing of your refrig-
erator door.
Max. 85 kg.
85
g. 8
g. 9
9
User Manual

Operation and function
g. 10
Electronic control
The electronic control ensures that the
temperatures set at the top and at the bot-
tom of the appliance are maintained. This is
achieved by means of an advanced control
of the refrigeration system, the heating ele-
ment, and the fan. The set temperature will
be stored in the event of power failure.
The electronic control has the following
functions:
● On/o󰀨 switch
● Light switch*
● Temperature setting
● Temperature indication
● Alarm for too high and too low tempera-
tures
● Door alarm
* The light may either be turned on
constantly or only when the door is open.
Temperature indication
The display shows the actual temperature.
The upper digits of the display indicate the
temperature at the top of the appliance, and
the lower digits of the display indicate the
temperature at the bottom of the appliance.
The temperature indicator is equipped with
a built-in lter which simulates the actual
temperature in the bottles. Consequently,
the indicator does not react on short-term
uctuations of the air temperature
Temperature setting
The thermostat is equipped with a child lock
device. This device is activated by pushing
the “up and down” buttons simultaneously.
After approx. 3 seconds “Pof” ashes in
the display. Then the actual temperatures
are shown as usual. In addition, the set
temperatures can be shown by pushing
and , respectively.
The child lock device is cancelled by
pushing the “up and down” buttons simul-
taneously. After approx. 3 seconds “Pon”
ashes in the display, and the temperature
can be set.
Temperature setting at the top
of the appliance
Push . Then the temperature at the top
of the appliance can be adjusted up and
down by means of the “up and down” but-
tons. The temperature can be adjusted from
8 to 22°C, however so that the temperature
cannot be set at a lower temperature than
the actual set point for the bottom tempera-
ture sensor.
Temperature setting at the bot-
tom of the appliance
Push . Then the temperature at the bot-
tom of the appliance can be adjusted up
and down by means of the “up and down”
buttons. The temperature can be adjusted
from 5 to 22°C, however so that the tem-
perature cannot be set at a higher tempera-
ture than the actual set point for the upper
temperature sensor.
10
User Manual