Viola Systems Arctic 3G Gateway 2622 User manual

Arctic 3G/LTE/Substation Gateway
Quick Start Guide v1.3
This document covers the following product(s):
-Arctic 3G Gateway (2622)
-Arctic LTE Gateway (2625)
-Arctic Substation Gateway (2651)
More documentation is available at http://www.violasystems.com/docs
1. Overview
This document is a short description how to power up the Arctic Gateway series
product and how to get it operational. This document contains the following
sections:
•Physical connections and switches
•Inserting a SIM card
•Setting an IP address using a web browser
•3G/LTE network settings
Viola Systems Ltd. Phone: [phone] www.violasystems.com [e-mail]

1. Reset button
2. Error LED
3. Ethernet WAN port
4. Ethernet LAN ports (3 port switch)
5. Status LEDs
6. Serial console port (115200 8N1)
7. SIM card slots
Figure 1. Front Panel
NOTE: Ethernet LAN ports 0-2 support both crossover and direct Ethernet cabling.
2. Physical connections and switches

Figure 2. Back Panel
1. Serial port 1
2. Serial port 1 configuration DIP switches ( see user manual)
3. Serial port 2
4. Power switch
5. Power connector (15-30 VDC)
6. Antenna connector
3. SIM Card
SIM card slots are located on the front panel of the Arctic device (see figure 1).
Insert the SIM-card (contacts facing down) into the SIM1 slot when the device is
powered off.

4. Setting an IP Address Using a Web Browser
•Connect the Ethernet cable between the Arctic device LAN port and your
computer.
•Configure your computer to use the same IP address space as the Arctic device
(for example, your computer IP could be 10.10.10.11 with a netmask
255.0.0.0). Check with ping command.
•Connect to the Arctic device using the web browser. The default address of the
Arctic is https://10.10.10.10/. Please make sure to use https and not http (see
figure 3)
•Login to the device, the username is viola-adm and the default password is
violam2m Note! It is highly recommended that the default password is
changed before the product is connected to a public network.
Figure 3. Browser https example

5. Wireless Network Settings
•Login to the Arctic web user interface using your web browser.
•Navigate to Network-->Mobile WAN subpage (see figure 4)
Figure 4. Login to the Arctic web user interface
•Set Access Point Name (APN) appropriately (usually INTERNET or
operatorname.com). This setting is depends on the mobile operator,
please refer to your operator documentation for the correct APN
setup.
•Setup other settings if needed (usually PIN-code, authentication,
username and password)
•Reboot Arctic device and check settings from System--> Status page
Figure 4. Mobile WAN settings