Viper AS4335C User guide

Place the brush or the pad-holder under the
deck and Lower the deck or the brush/ pad
holder by pressing the pedal. The squeegee
is raised and lowered with the deck.
Press one of the safety-switch levers on the
handle to engage the brush/pad-holder,
then release it.
Press solution and vacuum buttons on and
start cleaning by placing the hands on the
safety switches.
Use and maintenance
Operating guidelines AS4335C
July 2020
Remove the red cover, ll the tank with
clean water and use maximum temperature
40 degree. Add appropriate low foaming
detergent according to dosage information.
Check the level of water with the red ball
on the left side of the machine.
Connect the power supply plug to the
electrical mains and press machine ON
button.
Lift the deck by pressing the pedal.
Solution ow can be adjusted according to
the scrubbing need
Lift the squeegee up by hand until it locks in
up position and turn suction off for double
scrubbing.
To go back to working mode, use the red
lever to release the squeegee and turn
suction on again.
When scrubbing is complete, turn off
the machine to perform the following
maintenance.

Maintenance
Operating guidelines AS4335C
July 2020
When scrubbing is complete, turn off the
on/off button to perform the following
maintenance.
Daily: Empty the clean water tank using
the solution tank drain knob under the
machine.
Daily: Empty the recovery tank using the
recovery empty hose. Bend the soft part
before removing the cap to control the
ow.
Daily: Inspect and rinse the oat ball cage
and inspect and clean the lid gasket if
required.
Local Viper dealer:
Phone number:
SN:
Daily: Remove the squeegee, and clean.
Inspect the blades and ip them or replace
them if required.
To remove the brush/padholder lift the deck
by pressing the pedal and manually release
the brush/pad
Weekly: Inspect the solution lter and
clean if required.
Daily: Leave the recovery tank lid open
after it’s been cleaned to avoid bad odor.