Viper CEX410 User guide

Use and maintenance
Operating guidelines CEX410
July 2018
Fill solution tank with fresh
water. Add low foam
detergent
Plug in power cable Adjust handle for ergonomic
operator height
Switch on vacuum and
solution and Turn on the main
switch to start the machine
Press handle switch and start cleaning by moving the machine backwards. When you near the end of your
cleaning path release the handle switch and continue a new cleaning path. Overlap slightly to insure no dirt
is missed
To install accessory: remove the suction hose on the lid and connect it to the
empty left connection. Connect the accessory suction hose in the lid and
connect the solution hose in quick coupling in the right bottom part. When
both are connected make sure the machine in parked on the stand and start the
machine with pump and suction buttons activated and start working with the
accessory.
Adjust the brush pressure to
have the desired traction
according to your needs as
this changes with different
type of carpets
Optional upholstery nozzle for furniture
cleaning and optional floor tool for cleaning in
difficult areas available
Unplug the machine

Maintenance
Operating guidelines CEX410
July 2018
Unplug the machine Empty the recovery tank by
using the drain hose
Clean the recovery tank Clean the float ball system
inside. Clean the lid gasket
Local Viper dealer:
Phone number:
SN:
Empty the solution tank
When the brush is removed clean the
brush housing and if needed check the two
spray nozzles
At the bottom of the machine you can
access to the solution filter. Keep the filter
clean
Store machine in parked position
Pull the brush out by the left side and clean
it. To install again connect the right side first
then push the left side of the brush in place.
Remove the suction nozzle and clean it
Leave recovery tank cover open