Visonic NEXT K9-85 User manual

DE1274 1
NEXT K
NEXT KNEXT K
NEXT K9-85
9-859-85
9-85
Pet-Immune Digital PIR with TMR™Signal Processing Installation Instructions
1
11
1. INTRODUCTION
. INTRODUCTION. INTRODUCTION
. INTRODUCTION
The NEXT K9-85 is a pet-immune microprocessor-controlled PIR
detector, designed for easy installation, free of vertical adjustment.
It features a cylindrical lens with uniform detection sensitivity up to a
distance of 12 meters (40 ft), and immunity to pets weighing up to
38 kg (85 lb).
Advanced True Motion Recognition™ algorithm allows the NEXT
K9-85 to distinguish between the true motion of an intruder and any
other disturbances, which cause false alarms. In addition, Target
Specific Imaging™ (TSI) technology is employed for distinction
between human beings and pets.
A TST (Test) input permits switching the detector to the walk test
mode remotely without removing the front cover. An on-board
motion event jumper determines whether 1 or 2 consecutive
motion events would trigger an alarm. Figure 1. General View Figure 2. Inside View
2
22
2. SPECIFICATIONS
. SPECIFICATIONS. SPECIFICATIONS
. SPECIFICATIONS
Input Voltage: 9 to 16 VDC
Current Drain: About 8 mA @
12 VDC
OPTICAL (see Figure 3)
Lens Data
No. of Curtain Beams: 9
Max. Coverage: 12 x 12 m
(40 x 40 ft) / 90°
Pet Immunity: Up to 38 kg (85 lb).
ALARM and TAMPER
Alarm Output: Solid-state relay,
N.C., up to 100 mA / 30 V, ~30 Ω
internal resistance. Circuit opens
for 2-3 seconds upon alarm.
Alarm Indication: LED lights for
2-3 seconds. Figure 3. Coverage Pattern
Event Counter: Selectable, 1 or 2 motion events
Tamper Contacts: Normally closed, 50 mA resistive / 30 VDC
MOUNTING
Surface or corner, at the height of 1.8 to 2.4 m (6 to 8 ft)
Note: Base allows single-sided corner mount at 45° to wall.
ACCESSORIES:
BR-1: Surface mounted swivel bracket, adjustable 30° down and
45° left/45° right.
BR-2: BR-1 with a corner adapter
BR-3: BR-1 with a ceiling adapter
ENVIRONMENTAL
Operating Temperature: –10°C to 50°C (14°F to 122°F)
Storage Temperature: –20°C to 60°C (–4°F to 140°F)
RFI Protection: Greater than 20 V/m (20 MHz to 1000 MHz)
PHYSICAL
Size (H xWxD): 94.5 x 63.5 x 49.0mm(3-11/16x 2-1/2x1-15/16”)
Weight: Approximately 50 g (1-3/4 oz)
PATENTS: U.S. Patents 5,693,943 !6,211,522 !D445,709
(another patent pending)
3
33
3. INSTALLATION
. INSTALLATION. INSTALLATION
. INSTALLATION
3.1 General Guidelines
Do not aim at heat
sources Do not expose to air drafts Do not install outdoors Avoid direct sunlight Keep wiring away from power cables Do not install behind partitions Mount on solid, stable surfaces
Important! The detector is immune to 38 kg
(85 lb) animals moving on the floor or climbing
on furniture as long as the activity takes place
below 1 m (3 ft). Above the 1 m (3 ft) height
limit, the detector is immune to 19 kg (42 lb)
pets, but the pet immunity will decrease as
the pet gets closer to the detector. It is
therefore recommended to select a mounting
location that minimizes potential close
proximity of animals.
Correct use of the optional brackets:
With pets: in pet immune applications,
optional brackets should be used for
horizontal alignment only - the detector
should remain vertical (perpendicular to the
ground).
Without pets: To obtain the best possible
coverage where no pets are present, use a
bracket and tilt the detector 20º down.

2DE1274
3.2 Illustrated Installation Procedure
WIRES
RECOM-
MENDED
CORNER
MOUNT
SURFACE
MOUNT
(1 OF 2)
1.8-2.4m (6-8ft) above ground. For range above
10m (30ft) recommended height is up to 2.1m (7ft)
SINGLE-
SIDE, 45°
ANGLED
MOUNT
SINGLE-
SIDE, 45°
ANGLED
MOUNT ROUTE
WIRES INTO
B
INSERT
DOWELS
C
PUT P.C.
BOARD
D
MARK
DRILLING
A
BASE VIA THE
REAR CHANNEL
& ATTACH BASE
TO WALL WITH
TWO SCREWS
BACK IN PLACE
POINTS AND
DRILL IN WALL
4
44
4. SPECIAL COMMENTS
. SPECIAL COMMENTS. SPECIAL COMMENTS
. SPECIAL COMMENTS
Even the most sophisticated detectors can sometimes be defeated or may fail to
warn due to: DC power failure / improper connection, malicious masking of the
lens, tampering with the optical system, decreased sensitivity in ambient
temperatures close to that of the human body and unexpected failure of a
component part.
The above list includes the most common reasons for failure to detect intrusion,
but is by no means comprehensive. It is therefore recommended that the
detector and the entire alarm system be checked weekly, to ensure proper
performance.
An alarm system should not be regarded as a substitute for insurance. Home
and property owners or renters should be prudent enough to continue insuring
their lives and property, even though they are protected by an alarm system.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in residential installations. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio and television reception. However, there is no guarantee that
interference will not occur in a particular installation. If this device does cause such interference,
which can be verified by turning the device off and on, the user is encouraged to eliminate the
interference by one or more of the following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the device and the receiver.
– Connect the device to an outlet on a circuit different from the one that supplies power to the receiver.
– Consult the dealer or an experienced radio/TV technician.
WARNING! Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
VISONIC LTD. (ISRAEL): P.O.B 22020 TEL-AVIV 61220 ISRAEL. PHONE: [phone], FAX: [phone]
VISONIC INC. (U.S.A.): 10 NORTHWOOD DRIVE, BLOOMFIELD CT. 06002-1911. PHONE: [phone] FAX: [phone]
VISONIC LTD. (UK): FRASER ROAD, PRIORY BUSINESS PARK, BEDFORD MK44 3WH. PHONE: [phone] FAX: [phone]
INTERNET: www.visonic.com
VISONIC LTD. 2002 NEXT K9-85 DE1274- (REV. 3, 10/02) Refer to a separate warranty statement
1 2
4
3
65
Set
j
um
p
ers as needed
O
p
en holes in base
Disassemble unit
Mount base
W
alk-test the covera
g
e area
W
ire u
p
the terminal block