VITACON C6 User manual

[phone] Option 2 [e-mail] Rev 20210928
1
Contents:
1. VitaScan LT Bladder Scanner Probe (refer to the Quick Start that accompanied the Scanner Probe for instructions on how to scan)
2. Medical Grade Tablet
3. Rolling Medical Cart with Probe Holder, Cord Cleat and Basket
2
ASSEMBLE THE LOWER HALF OF THE CART
C6 ASSEMBLY INSTRUCTIONS
1.a Install the casters onto the base.
1.b Insert the bottom post into Base.
1.c Lay assembly on its side to access the base bottom.
Grip the post to prevent rotation. Secure the post to the
base using the Hex Wrench. Return stand to upright
position.
It is important that you fully secure the bolt using
the Hex Wrench so that it is flush. Do not hand
tighten.
ASSEMBLE THE UPPER HALF OF THE CART
2.a Extend the top post and tighten
the Adjustment Knob to hold it in
place.
2.b Attach the Basket’s Mounting Bracket to the
Basket. Loosen the Bracket leaving enough gap to
slide the Bracket onto the Upper Post.
2.c Slide the Basket onto the upper post opposite the
Adjustment Knob. Position the Basket approx. midway
down the post and tighten the bracket evenly.
2.d Attach the Cord Cleat to the back of the
Basket’s Mounting Bracket using the top
two holes.
Install with the “lip” at the bottom
(as shown).
2.e Insert the Velcro strap with the
fuzzy side on the outside.
2.f Attach the Tablet’s Power Cord to the Cord Cleat
and organize the cord.
Install with the transformer resting on the
“lip”. Secure the Velcro tightly.

[phone] Option 2 [e-mail] Rev 20210928
4
Allow the Tablet to fully charge before first use. Always charge Tablet when not being used.
It is recommended to operate this equipment on battery power. To avoid the risk of electrical shock, use only properly grounded
equipment. Grounding reliability can only be achieved when equipment is connected to a receptacle marked “Hospital Grade” or
equivalent. Run Tablet on battery whenever the integrity of the external protective earth conductor arrangement is in doubt.
MOUNT THE TABLET TO THE CART
3
4.a Connect the Power Cord to the Tablet and charge fully before use.
4.b Turn the Tablet on by pressing and holding the power button. Wait until the Tablet fully boots-up and automatically launches the VitaScan
Software.
4.c (optional) Connect the Tablet to your secure Wi-Fi network and install network printer drivers.
4.d (optional) Create Default Save Folder. From within the VitaScan software, select the
Save
button and navigate to the desired saving location (local
or on the network). When prompted, select
Yes
to make this the default path.
4.e (optional) From within the VitaScan software, select the
Setup
button and enter your Facility’s Name.
2.g Slide the Probe Holder onto the post approx. 8 to 10 inches from
the top with the Probe Sleeve located to the right. Align with the
Basket and then tighten the bracket evenly.
2.h Attach the Gel Holder to the Probe Holder Bracket.
3.a Insert the stem of the Tablet Mount into the upper post and
align with the post holes. Secure using the 3 supplied screws.
Swivel the Tablet side-to-side until aligned with the Basket.
3.b Connect the Scanner Probe to the Tablet’s USB port and then place the
Scanner Probe into the Probe Holder. The cart assembly is complete. Your
scanner should closely match the image above.
If the cart is “wobbly” ensure the post is properly secured to the base
(see step 1.c).
CHARGE SCANNER AND SET DEFAULTS