P/3P/4INSTRUCTION OF USE:1. Unplug the Power Cord (8), and turn the Switch (6) to the “Off” or “0” position.2. Unscrew the Water Injection Cover Cap (2), Fill the Water Tank with cool water till MAX LINE; and replace the Valve Cap, in order to prolong the lifetime of your steamer, we recommend using distilled or de-mineralized water, Do not let the steamer work with a dry water tank or else you can damage the unit.3. Plug the unit into an electrical outlet.4. Turn on the Switch (6), Steam should start flowing from the spout in 2-4 mins according to water capacity.5. When you finish working with your steam iron, turn the switch off by switching to “Off” or “0” position and pull plug out from the outlet.USING MINI-IRONING BOARD:1. Using ironing board for iron clothes and trousers2. It will be easy and fast during Ironing;3. During Ironing, move spout and Ironing board togetherBRUSH INSTALLATION:1. Turn off the steamer and wait until no steam emits from the Steam spout.2. Fabric brush's pegs aim and insert the holes on the Steam spout.3. Push the brush and firm it in place.WATER INJECTION:1. Before injecting the water, please turn the unit off, and pull the plug,2. Put the unit on table steadily and let it cool;3. Open the cover, then inject the water;4. Please check the water lever make sure not exceed Maximum water lineCLEANING AND STORAGE:We recommend you follow this procedure at least once per month to extend machine working periods;1. Turn the Switch to “off” or “0” position.2. Unplug the unit from the power outlet.3. Ensure the steamer to cool for at least 30 minutes.4. Remove and drain the Water Tank. Rinse the water tank with fresh water and drain completely.5. Store in a cool and dry place.REMOVING MINERAL DEPOSIT:Different water sources contain minerals and the sediment may cause mineral deposit in the steamer and affect the free flow of steam. To reduce the occurrence of mineral deposit in the steamer, de-mineralized or distilled water is recommended.To remove the mineral deposit, please follow below procedure1. Turn the unit off, and unplug the power cord.2. Drain the Water flume and empty water from the Water Tank.3. Mix a solution of 50% vinegar and 50%water or Citric acid .4. Let unit power on and work 5-6 minutes.5. Cool unit about 30 minutes, and pour water out;6. Reassemble the unit and operate normally.
