Vivitek QUMI Q9 User manual

User Manual
www.vivitekcorp.com
Q38

i
TABLE OF CONTENTS
Important Safety Information ..............................................1
Symbols Used .......................................................................... 1
General Safety Information ......................................................2
Q9 Installation Notice ..............................................................2
Power Supply Safety ................................................................3
Cleaning Q9.............................................................................3
Control Warning .......................................................................3
Regulatory Compliance ...................................................... 4
FCC Warning ............................................................................4
Canada ....................................................................................4
Safety Certifications ................................................................4
Disposal and Recycling ............................................................4
Introduction....................................................................... 5
About this Manual ....................................................................5
Q9 Main Features.....................................................................5
Package Contents.............................................................. 6
Your Projector ................................................................... 7
Top and Front-Left View .......................................................... 7
Rear View ................................................................................8
Bottom View ............................................................................8
Remote Control.................................................................. 9
Remote Control Keypad ...........................................................9
Plug in WiFi dongle in Q9 ........................................................11
Using Your Remote Control .................................................... 12
Operating Range ...........................................................................12
Infrared transmission mode............................................................12
Remote control Bluetooth pairing ...................................................12
Replacing Batteries .......................................................................13
Powering the Projector .....................................................14
Powering On/Off the Projector ............................................... 15

-ii -
Start up wizard .................................................................17
Making Connections .........................................................18
Connecting to a Wi-Fi Network .............................................. 19
Using the Projector .......................................................... 20
Adjusting the Focus ...............................................................20
Playing Media Files from a Storage Device (USB Flash Drive or
internal storage) .................................................................... 21
Submenu setting ....................................................................23
USING THE SUB-SETTINGS MENUS .................................. 24
Screencasting with a Smartphone, Tablet, or PC ....................26
Before the Screencasting ............................................................. 26
Screencasting with an iOS Device ................................................. 27
Screencasting with a MacOS Device .............................................. 28
Screencasting with an Android Device ........................................... 29
Screencasting with a Windows PC ................................................. 29
Playing from a Video Source (HDMI or Type-C) ...................... 31
Bluetooth®Connections ................................................... 33
Connecting the Projector to Bluetooth Devices ......................33
The Home Screen ............................................................ 35
Customizing the App Shortcuts on the Home Screen ..............36
Using the Settings Menus ................................................ 37
Settings .................................................................................38
General ..................................................................................39
Display ..................................................................................40
Picture ................................................................................... 41
Sound ....................................................................................42
Network.................................................................................43
Apps ......................................................................................44
System Setting ......................................................................45
Troubleshooting/FAQ ....................................................... 46
Tips .......................................................................................46
Image Problems .....................................................................46
Screencasting Problems......................................................... 47

- iii -
Remote Control Problems....................................................... 47
Audio Problems ......................................................................48
FAQs......................................................................................48
Vivitek Support Site ...............................................................49
Additional Information...................................................... 50
Projection Distance vs Projection Size ...................................50
Timing Mode Table ................................................................ 51
Specifications ........................................................................53

1
IMPORTANT SAFETY INFORMATION
IMPORTANT:
It is strongly recommended that you read this section carefully before using Q9. These
safety and usage instructions will make sure you enjoy many years of safe use of Q9.
Keep this manual for future reference.
Symbols Used
Warning symbols are used on the unit and in this manual to alert you of hazardous situations.
The following symbols are used to call attention to important information.
NOTE:
Provides additional information on the topic at hand.
IMPORTANT:
Provides additional information that should not be overlooked.
CAUTION:
Alerts you to situations that may damage the unit.
WARNING:
Alerts you to situations that may damage the unit, create a hazardous environment, or
cause personal injury.
Throughout this manual, component parts and items in the OSD (On-Screen Display) menus
are denoted in bold font as in this example:
“Press the Menu button on remote control to open the Settings menu”.

2
General Safety Information
RG1 IEC 62471-5:2015
Do not open the casing. There are no user-maintainable parts inside the machine. For any
maintenance, please contact a qualified service technician.
Follow all warnings and precautions on the machine or in this Manual.
According to its design, the projection light source is extremely bright. To avoid harm to
your eyes, do not look straight at the lens when the LED is ON.
Do not place the machine on unstable surface or stand.
Avoid using the system near water, in direct sunlight, or near a heating device.
Do not place any heavy objects (e.g., books or bags) on the unit.
Q9 Installation Notice
Allow at least a 500mm (20”) clearance around the exhaust vent.
Make sure that the intake vents do not recycle hot air from the exhaust vent.
When operating Q9 in an enclosed space, make sure that the surrounding air temperature
within the enclosure does not exceed the operating temperature while Q9 is running, and
the air intake and exhaust vents are unobstructed.
All enclosures should pass a certified thermal evaluation to make sure that Q9 does not
recycle exhaust air, as this may cause the device to shut down even if the enclosure
temperature is with the acceptable operating temperature range.
CAUTION:
Avoid usage of Q9 in dusty environments.

3
Power Supply Safety
Only use the supplied adapter.
Do not place anything on the cord. Place the cord where it will not be in the way of foot
traffic.
Remove the battery from the remote control when storing or not in use for a prolonged
period.
Cleaning Q9
Before cleaning, disconnect the power supply cables. Refer to Powering On/Off the
Projector on page 15.
NOTE:
Q9 will be warm after usage. Allow Q9 to cool down before storing away.
Control Warning
Before installing and using Q9, read the regulatory notices in the Regulatory Compliance
on page 4.

4
REGULATORY COMPLIANCE
FCC Warning
This equipment has been tested and found to comply with the limits for a Class B digital device
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his/her own
expense.
Any Changes or modifications not expressly approved by the parties responsible for
compliance could void the user’s authority to operate the equipment.
Canada
This class B digital apparatus complies with Canadian ICES-003.
Safety Certifications
Projector: CE, REACH, ROHS, WEEE, FCC, TUV NORTH AMERICA, CB
Power Adapter: DOE, WEEE, FCC, UL, EAC, TUV-GS, CB, PSB, TUV-S, EAC, KCC, CCC, CECP,
BIS, BSMI, ISC
Disposal and Recycling
This product may contain other electronic waste that can be hazardous if not disposed of
properly. Recycle or dispose in accordance with local, state, or federal Laws. For more
information, contact the Electronic Industries Alliance at www.eiae.org.
DISPOSAL:
Do not use household or municipal waste collection services for disposal of
electrical and electronic equipment. EU countries require the use of separate
recycling collection services.

5
INTRODUCTION
About this Manual
This manual is intended for end users and describes how to install and operate Q9. Wherever
possible, relevant information—such as an illustration and its description—has been kept on
one page. This printer-friendly format is both for your convenience and to help save paper,
thereby protecting the environment. It is suggested that you only print sections that are
relevant to your needs.
Q9 Main Features
Native 1080P resolution with a maximum resolution of 4K UHD (3840x2160).
Texas Instruments DLP® chip technology for long-lasting precise color, image quality and
low power consumptions.
Long-life energy efficient LED light source with up to an estimated 30,000 hours of
operation.
Enjoy a large widescreen image up to 3.2m (120") diagonally for one or a group.
Advanced Quad-Core CPU with an ultra-fast Android™ operating system.
Customized dual 3-watt speakers pump out crisp, clear, and dynamic sound for an
incredible theatre-quality audio experience.
Bluetooth®enabled for wireless free connection to a keyboard, mouse, headphone or other
device.
Assortment of connectivity options including Type C display, HDMI, USB and earphone
audio-out.
PC-free playback of photos, videos, audio, and office files with the integrated player.
Dual mode Remote for Infrared and Bluetooth 2.4G remote control with air mouse function.
Lightweight appearance, with stepless adjustable feet to adjust the angle, and a dedicated
carrying bag for easy carrying and moving.
Tripod port and ceiling mount hole for convenient projector setup and positioning.

6
PACKAGE CONTENTS
Q9
Remote Control with Battery
Adapter
Carry Bag
Documentation
Wi-Fi / Bluetooth Dongle

7
YOUR PROJECTOR
Top and Front-Left View
1
Lens
4
Power Button
2
Front IR Sensor
5
LED Status Indicator
3
Focus
LED status
LED status
Description
Ready to power on (Standby)
Projector standby and ready for turn on
Cooling
Projector cooling and ready to turn on when
LED turn to solid Red
System initial
Projector on in process
Power On : Normal
Projector on
Temperature Err
Temperature Err and Projector will be in
Standby mode
Light source Err
Light source Err and Projector will be in Standby
mode
Fan Err
Fan Err and Projector will be in Standby mode

8
Rear View
1
RJ45 Lan Port
5
Audio Out (3.5mm) Jack
2
Type-A USB Port
6
DC In Port
3
Type-C DisplayPort
7
Rear IR Sensor
4
HDMI Port
Bottom View
1
Ceiling mount hole
4
WiFi Dongle cover
2
Triple connector
5
WiFi Dongle
3
Angle free adjustment foot

9
REMOTE CONTROL
Remote Control Keypad
1
Power ON/OFF
7
Volume ‒
13
Down
2
Setting
8
LED status
14
Return
3
Up
9
Source
15
Focus in
4
Left
10
Mouse
16
Focus out
5
Sub Menu
11
Enter
17
Home
6
Volume +
12
Right
NOTE:
LED status: Red - IR mode, Green - BT mode, Flashing Green - BT pairing mode
Mouse: Only active in Bluetooth mode.

10
IMPORTANT:
Avoid using the projector with bright fluorescent lighting turned on. Certain high-
frequency fluorescent lights can disrupt remote control operation.
Be sure nothing obstructs the path between the remote control and the projector.
If the path between the remote control and the projector is obstructed, you can
bounce the signal off certain reflective surfaces such as projector screens.
NOTE:
Complies with FDA performance standards for laser products except for deviations
pursuant to Laser Notice No. 50, dated June 24, 2007.
CAUTION:
Use of controls, adjustments or performance of procedures other than those specified
herein may result in hazardous laser light exposure.

11
Plug in WiFi dongle in Q9
Q9 wifi & Bluetooth funciton need a dongle plug in to enable function
Please find Wifi dongle in Accessory box and Plug in Q9 before Q9 first power on.
Loosen the screw on the WiFi Dongle cover.
Remove the WiFi Dongle cover.
Install the WiFi Dongle.
Replace the cover and lock the screws.

12
Using Your Remote Control
Operating Range
●The remote controller is duel type, both has infrared and Bluetooth mode to control
projector
●In the Bluetooth mode, the operating distance can be more than 10 meters, and there is no
directivity.
●In infrared mode it is not necessary to point the remote directly at the projector.
●The Remote Controller will function properly within a distance radius of about 7 meters
(23 feet)and vertical angle of 15 degrees above or below the projector level.
Infrared transmission mode
NOTE:
If the projector does not respond to the Remote Controller, Move to a closer range or
Replace batteries..
Remote control Bluetooth pairing
●Please follow Startup Wizard to setup Q9 when you first boot Q9.
●If you miss the Remote pairing process in Startup Wizard, you could pare Remote control
any time by following process:
1. Put Remote near Q9 Projector, and long press "Sub menu" and "Return" key till remote
LED flash green to enter pairing mode. Please see following Picture

13
2. When pairing success, screen show green check mark and LED flashing stop.
Replacing Batteries
●Slide IN/OUT the battery compartment cover.
●Insert the battery with the positive side facing up.
CAUTION:
1.Only use AAA batteries (Alkaline batteries are recommended).
2.Dispose of used batteries according to local ordinance regulations.
3.Remove the batteries when not using the projector for prolonged periods.

14
POWERING THE PROJECTOR
To supply power to the Q9:
1. Connect the power cable to a power socket
2. Connect the power cable to the supplied adapter.
3. Connect the adapter cable to the DC In port on the projector.
4. Once the adapter and power cable are connected to the projector, the LED status indicator
on the top of the projector will illuminate indicating the standby status (refer to Top and
Front-Left View on page 7for more information on LED behavior).

15
Powering On/Off the Projector
To power on the projector:
1. Press the power ( ) button on the top of the projector or the power () button on the
remote control.
2. The fans will begin to operate and the Vivitek logo will appear on the screen:

16
To power off the projector:
1. Press the power ( ) button on the top of the projector or the power ( ) button on the
remote control.
2. A message will appear on the projected screen to confirm power off. Select OK and press
the enter ( ) button.