Vivo DESK-V130EW User manual

Black Electric Multi Motor Corner Desk Frame
Instruction Manual
SKU: DESK-V130EB
Scan the QR code with your mobile device or follow the link
for helpful videos and specifications related to this product.
https://vivo-us.com/products/desk-v130eb
[email protected]om www.vivo-us.com 309-278-5303
Chat live with an agent!
GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST

2
If you do not understand these directions, or if you have any doubts about the safety of the installation,
please call a qualified technician. Check carefully to make sure there are no missing or defective parts.
Improper installation may cause damage or serious injury. Do not use this product for any purpose that is
not explicitly specified in this manual and do not exceed weight capacity. We cannot be liable for damage
or injury caused by improper mounting, incorrect assembly, or inappropriate use.
WARNING!
PACKAGE CONTENTS
1 (x3)
Side Brackets
2 x2)
Foot
3(x4)
Crossbar
4(x2)
Leg with
Frame (side)
5 (x1)
Leg with Corner
(side)
6(x1)
Extension
Frame
7 (x1)
Control Unit
8 x1)
Power Cord
9(x1)
Control Panel
10 (x1)
Extension
Cord (long)
11 (x2)
Extension
Cord (short)
ELECTRICAL SAFETY INSTRUCTIONS
THIS PRODUCT IS POWERED BY ELECTRICITY. IN ORDER TO AVOID BURNS, FIRE AND ELECTRIC
SHOCK, PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY.
• DO NOT CLEAN PRODUCT WHILE POWER IS CONNECTED.
• DO NOT DISASSEMBLE OR REPLACE COMPONENTS WHILE POWER IS CONNECTED.
• NEVER OPERATE THE SYSTEM WITH A DAMAGED CORD OR PLUG. PLEASE CONTACT YOUR
SELLER TO REPLACE DAMAGED PARTS.
• NEVER OPERATE SYSTEM IN DAMP ENVIRONMENTS OR IF ANY ELECTRICAL COMPONENTS HAVE
MADE CONTACT WITH LIQUIDS.
• ALTERATIONS OF THE GIVEN POWER UNIT ARE NOT ALLOWED.
• OUTDOOR USE IS PROHIBITED.
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
A x28)
M5x16
B(x26)
M6x12
C (x5)
Foot Pad
D x14)
M6x16
E(x2)
M8x12
F (x1)
4mm Allen
Wrench
G x1)
5mm Allen
Wrench
H(x2)
Desktop Connecting
Plate
I(x8)
Cable Clip
NOTE: Some extra screws are included.

3
264lbs
(120kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
ASSEMBLY STEPS
STEP 1
Loosen, but do not remove, screws in legs (4, 5). Tilt legs up and
into frames. Tighten screws with the 4mm Allen wrench (F).
TOOLS NEEDED
Phillips
Screwdriver
STEP 2
Attach feet (2) to side legs using four M6x12 screws (B) for each,
then tighten with the 4mm Allen wrench. Remove protective film
from foot pads (C) and install pads into feet.
Drill

4
STEP 3
STEP 4
Turn legs right side up. Secure frame on each leg with two M6x16 screws (D) using the 4mm Allen
wrench (F). Attach the side brackets (1) to the frames using two M6x16 screws for each and tighten
with the 4mm Allen wrench (F).
Attach extension frame (6) to leg with frame (corner)
using M8x12 screws (E) and tighten with the 5mm Allen
wrench (G). Slide the crossbars (3) into the frames, then
adjust the size of the frame to fit your desktop. Tighten
sixteen M6x12 screws (B) into the underside of the
frames using the 4mm Allen wrench (F) to secure the
adjusted length. E

5
STEP 5
Place desktop(s) on the assembled desk frame and mark drilling locations for screw holes with a
pencil. Remove desktop(s) and drill 3/8" (10mm) deep pilot holes using a 1/8" (or 3mm) drill bit.
Place the desktop(s) back onto the frame and secure using fourteen M5x16 screws (A). If using two
desktops, use the connecting plates (H) and eight M5x16 screws (A) to join the desktops

6
STEP 6
Remove the protective film from the control panel (9). Mount the control panel and control unit (7) to
the underside of the desktop using four M5x16 screws (A). Use the extension cords (10, 11) to connect
the motors to the control unit, then connect the control panel and power cord (8). Attach cable clips (I)
where desired.
AACC
HHSSMM11MM
22MM33
7
Figure 1: The controller is prohibited from
suspension testing to avoid false alarm.
Figure 2: The controller must be
fixed before testing.
Figure 2Figure 1

7
STEP 7
Plug the power cable into an AC wall outlet, then use the control panel to adjust the height.
CAUTION!
Failure to follow these instructions may result in property damage and/or personal injury.
Do not exceed desk
weight limit.
Keep area of vertical
motion free of
obstacles.
Keep weight on desk
balanced for correct
operation and longer
life of components.
Leave enough slack in
cables to allow for full
range of vertical motion.
PLEASE NOTE: The control unit has a gyroscope sensor and MUST be fixed to the desk for correct
operation.

LAST UPDATED: 04/15/2021
REV2.1
Open Monday - Friday 7:00am - 7:00pm CST,
our dedicated support team can oer immediate assistance with rapid response times. If any
parts are received damaged or defective, please contact us. We are happy to replace parts to
ensure you have a fully functioning product.
FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com
[email protected] AVG. RESPONSE TIME (within oice hrs): 1HR 8M
- 23% within < 15m
- 38% within < 30m
- 61% within < 1hr
- 83% within < 2hr
- 92% within < 3hr
Love your new VIVO setup and want to share?
Tag us in your photo! @vivo_us
AVG. RESOLUTION TIME (within oice hrs): < 15 M
www.vivo-us.com
Chat live with an agent!
AVG. RESOLUTION TIME (within oice hrs): 5M 4S
309-278-5303