2 3
ASSEMBLY STEPS
STEP 1
Place mount (A) on top of CPU and measure distance “a” between mounting holes using a tape
measure. Make 8 marks under desktop as shown in diagram.
PACKAGE CONTENTS
TOOLS NEEDED
22lbs
(9.98kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
WARNING!
Phillips
Screwdriver
A (x1)
Mount
B(x4)
So Pad
C(x8)
M4x16
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualied technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specied in this manual. Do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or
inappropriate use.
Drill
D(x2)
Cable Tie
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
a
66.7mm 66.7mm 66.7mm
66.7mm 66.7mm 66.7mm
a
STEP 2
Using a 1/16” bit, drill ⅜” into mounting holes.
Attach mount (A) to marked locations using
screws (C) and a phillips screwdriver.
STEP 3
Stick so pads (B) to mount (A) as shown in
diagram.
x4
STEP 4
Attach CPU to mount (A) making sure base
pads are placed in middle of CPU bottom.
Adjust straps to secure CPU in place.
WARNING: If strap gets stuck and won’t
continue to easily pull through while
tightening, STOP and either loosen strap
slightly or pull slack through clip before
continuing to
tighten. Failure to do so may result in
breaking the plastic clip. base pad
TightenLoosen
STEP 5
Use cable ties (D) to tie up ends of straps.
