Vivo E-FD55 FD55 User manual

Remote Contro for T Ceiin
Mount
User Guide
Email: [email protected]
Live chat: www.vivo-us.com
Call: 1-800-371- 6 4
- -Mode MOUNT  FD55
Remote Control Press and hold for seconds.
Operatin Instructions
Plug the mount in. The buzzer on the mount will beep once.
Step 
Reset tilt angle.
IF MOUNT IS INSTALLD ON A PITCHD SURFAC
Press and release to return the TV ceiling mount flat against the
ceiling surface. The system will beep once, then return the TV
ceiling mount flat against the ceiling surface.
Step 2
Repeat four times. The system will automatically find the
correct position, and it will automatically stop at the maximum
position.
Step 
Step 2
1

To recall Location 2, press and release the button, then press
the button. After the buzzer sounds once, the TV ceiling
mount will automatically adjust to Location 2.
MINIMUM POSITION: To adjust TV mount to minimum position
(resting against the ceiling), simply give it a slight push. The mount
will automatically return to minimum position.
Reca Memory
Manua Position Adjustment
*Find troubeshootin uide on bac+ cover.*
BUTTON FUNCTIONS
Downward movement
Upward movement
Memory button : Press and hold for seconds, the
buzzer will beep twice. Location is saved.
Memory button 2. Press and hold for seconds, the
buzzer will beep twice. Location 2 is saved.
Stop button
To recall Location 1, press and release the button, then press
the button. After the buzzer sounds once, the TV ceiling
mount will automatically adjust to Location 1.
MAXIMUM POSITION: To adjust TV mount to maximum position
(lowered completely), follow above instruction to return it to
minimum position. Once in the minimum position, give it a slight
push. The mount will automatically lower to maximum position.
2
Email: [e-mail]
Live chat: www.vivo-us.com
Call: 1-800-371- 6 4
For more VIVO products, check out our
website at
www.vivo-us.com.
Safety Warnin
If you do not understand these directions, or if you have any doubts
about the safety of the installation, please call a qualified technician.
If you receive any damaged or defective parts, please contact us. We
cannot be liable for damage or injury caused by inappropriate use.
Contact us at
Probem Soution
Remote
Control range
is too short
Replace the batteries. If the problem is not resolved, please
contact us to replace the remote control and IR receiver.
Abnormal
operation
Reset the system by following instructions. If problem is not
resolved, contact us to replace the product.
Mount will not
operate
Ensure power supply is properly connected to the product. If so,
ensure power outlet is working. If there is no beeping sound or
red light (power indication) on the TV mount, please contact us to
replace the power supply.
Abnormal
noise Please contact us to replace the product.
Troubeshootin Guide
Last updated: /14/2018