2
If you do not understand these directions, or if you have any doubts about the safety of the installation,
please call a qualified technician. Check carefully to make sure there are no missing or defective parts.
Improper installation may cause damage or serious injury. Do not use this product for any purpose that is
not explicitly specified in this manual and do not exceed weight capacity. We cannot be liable for damage
or injury caused by improper mounting, incorrect assembly, or inappropriate use.
WARNING!
REMOTE CONTROL OPERATING INSTRUCTIONS
Le
Movement
Stop Memory Button 1: Press
and hold for 2 seconds,
the mount will beep twice.
Location 1 is saved.
Memory Button 2: Press
and hold for 2 seconds,
the mount will beep twice.
Location 2 is saved.
BUTTON FUNCTIONS
Right
Movement
Recall Memory
Position 1
Recall Memory
Position 2
Install two AAA batteries (not included) in the remote.
OPERATION
Use le and right buttons to manually swing the mount in and out.
SAVE AND RECALL MEMORY
To save a certain location to memory, press and hold the mem1 or mem2 buttons for 2
seconds. The mount will beep, indicating the position has been saved to memory. To recall
memory locations, press the ( 1 ) or ( 2 ) button. The TV mount will automatically adjust to
saved memory locations 1 or 2.
INCREASE THE SWIVEL RANGE
The default swivel range of the TV mount is 0°-90°.
To increase the swivel range:
1. Adjust the TV wall mount to your desired position manually.
2. Unplug and re-plug the power. Press and hold “mem1” until you hear one beep. Repeat
this step five times until you hear two consecutive beeps; thie new swivel range is now saved
successfully. Note: The max swivel range is 170°.
ERROR INDICATIONS
Over-Current Protection: The unit makes a “beep beep” (2 beeps) once
Sensor indicates the mount is out of range: The unit makes a “beep beep” (2 beeps) twice
Sensor indicates an operating fault: The unit makes a “beep beep” (2 beeps) three times
Unit senses abnormal power: The unit makes a “beep beep” (2 beeps) four times
SWITCH REMOTE DIRECTION
To switch the remote direction, press and hold the up button for 5 seconds and wait for the
mount to beep.
