Vmar Dornier DO335 Pfeil User manual

2
2
CLEVIS
SURFACE CONTROL
CLEVIS
SURFACE CONTROL
EZ CONNECTOR
CLEVIS
Replacement 11E rear motor mount location Replacement 11I mount the brushless motor
to the rear motor location
Replacement 11G the rear motor install to
the rear location
3x10mm sheet metal screw
REPLACEMENT STAGE 13 REPLACEMENT STAGE 13 REPLACEMENT STAGE 13
13A- Elevator and rudder servos location
13B- Elevator servos connected to the elevator control rod, rudder
servo connected to the rudder and gear steering control rod.
Elevator control rod
Rudder control rod Nose steering control rod
For Rudder and Elevator
use control horn sets
with 3x25mm
4
For Aileron and Flaps
use control horn sets
with 3x28mm
Elevator servo location
Rudder servo location

Fuselage main component
STAGE 1 THROUGH STAGE 3 STAGE 1 THROUGH STAGE 3 STAGE 1 THROUGH STAGE 3
Left wing Right wing
Front cowl
Rear cowl
Left horizontal stab Right horizontal stab
Top vertical stab Bottom vertical stab
Fuselage
ATTACH WING TO THE FUSELAGEATTACH WING TO THE FUSELAGEATTACH WING TO THE FUSELAGE
Aluminum wing joiner tube size 12mm
diameter and 380mm long
1. Insert the wing tube onto right wing panel
the tighten with the butterfly nut to secure
to the fuselage
2 . same procedure the secure the left wing
panel to the fuselage
4x20xhex bolt
1 wooden washer
1 butterfly nut
1
Assemble in the
specified order.
Assemble left and right
sides the same way.
Drill holes with the
specified diametre.
Must be purchased
separately!
Apply threadlocker
(screw cement).
Pay attention here! Ensure smooth, non-binding
movement when assembling. Cut off excess.
Symbols used throughout this instruction manual, comprise:
Check all parts. If you find any defective or missing past, contact your local dealer or our VMARSHOP.
Read through the manual before you begin, so you will have an overall idea of what to do.
Do not overlook
This symbol!
Warning!Warning!Warning!
2mm
2
1
LR
X
3
2
1
A B
5
A B
30
Apply 30Minte Epoxy
Apply 5Minte Epoxy