VMP LCD-1 User manual

LCD-1 & LCD-1B

Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount.
Step 2
Attach the mounting plate to your LCD monitor using the M4
or M5 screws or as appropriate.
Step 3
Markthewallordesiredmountingsurfaceinpreparationofinstalla-
tion of wall mounting plate . Pre-drill if necessary and mount wall
plate to desired surface. Mount wall plate with small welded
rotation stoppers to the bottom of the plate. Warning: Please verify
that your mounting surface will support the combined weight of
your mount, mounting hardware, and monitor. Also verify that the
mounting surface is safe to drill through. If in doubt, please contact
a professional installer.
Step 4
Next determine which arm configuration you desire (double arm,
single arm, or near flush) and locate the correct arms ( for near
flush, for single arm, OR and for double arm). Attach the
desired wall arm or or to the wall plate using the 3/8”
screw , plastic flanges and nylon nut . Snap the plastic
cover onto the wall plate .
Step 2: Attaching the monitor
to the mounting plate
Step 3: Attaching the wall
plate to the mounting surface
(Lag Screws not included)
Step 4: Attaching the rear
force arm to the wall plate
3
2
11
20
17
2
8
1
5
19
18
1
281
1
6

Step 5
If your application calls for the single arm or near flush mount
configuration proceed to the next step. If your application calls
for the double arm configuration, attach the front force arm )
to the rear force arm using the metal pin , washers )
and the nylon nut .
Step 6
Attach the swivel bracket to the appropriate force arm
( , , or depending on your application) using a 3/8”
screw , washers , and nylon nut . Insert adjustable
screw into the back of the swivel bracket for use when
tilting the monitor.
Step 7
Attach the mounting plate to the swivel bracket using the
M6 screw and nylon nut .
Step 8
Insert end plugs into the force arms used by your application.
Insert the cable clips by pushing the arrow ends into the square
holes in the force arms.
Please verify that all nuts and screws are securely tightened.
Step 5: Attaching the front
force arm to the rear force arm
Step 6: Attaching the pivot
bracket to the front force arm
Step 7: Attaching the
mounting plate to the pivot
bracket
WARNING: The installer of these products must verify that
the mounting surface, ceiling or wall, will safely support the
combined weight of all attached equipment and hardware.
Video Mount Products will not be held liable for the improper
use or installation of its products.
Enjoy Your Mount!
10
3
2
11
12
16
11
4
5
8
15
4
13
3
1514
2
4