Voda Plumbingware Proline VPLNSC1 User manual

9421027 594951
Voda Plumbingware (NZ) Ltd | Freephone: 0508 367 366 | 5 Hewlett Street, Port Whangarei 0110 | vodaplumbingware.co.nz
Proline 15mm Shower Taps
VPLNSC1
Congratulations on your purchase of this high quality product from Voda Plumbingware.
Please read the following before installation and retain (along with your receipt) for future reference.
TECHNICAL SPECIFICATIONS
Suitable for All Pressures
Minimum Pressure = 17kPa
Maximum operating Pressure = 500kPa
Maximum operating Temperature = 65 deg. Celsius
For domestic use only.
CONFIGURATION
Mains Pressure systems Install as supplied.
Unequal Low systems Install as supplied.
Equal Low systems Install as supplied.
INSTALLATION
For pressures exceeding 500kPa, install a pressure reducing valve. Failure to do so will void the warranty.
• Before commencing installation, turn o the water supply.
• Remove the indicator and screw. Remove handle.
• Remove the flange and mounting washer.
• Fit the manifold to wall recess, ensuring all brackets are secured (i.e. tap bodies).
• Connect inlets to plumbing with either Crox or compression fittings.
• Make sure to have 10mm thread protruding when the wall lining is installed.
• Screw on the headworks (jumper should be attached), then the flanges, then the handles.
• Screw on the handles. Tighten handle using the screw and finally put on the indicator.
• Turn on the water supply.
• Check for leaks.
Indicator
Screw
Flange
Headworks
Body
Outlet

Voda Plumbingware (NZ) Ltd | Freephone: 0508 367 366 | 5 Hewlett Street, Port Whangarei 0110 | vodaplumbingware.co.nz
ATTACH PROOF OF PURCHASE HERE
WARRANTY
Please refer to our website for warranty information: www.vodaplumbingware.co.nz/warranty
In the unlikely event that this product fails during its warranty period, phone our Customer Service team
immediately on 0508 367 366 – as unauthorised removal of the product may void the warranty.
CARE AND MAINTENANCE
When cleaning your Voda product (including chrome, stainless steel, coloured or any other surface coating) you
must not use any type of astringent, abrasive or citric cleaners.
We recommend using only a so, damp cloth and on occasion a mild soap solution. Try to avoid excessive
scrubbing as this could cause damage and void your warranty.