Voda Plumbingware VSS040 Installation instructions manual

9 421027 596900
Stainless Single Function Slide Shower
Stainless Steel VSS040
Voda Plumbingware (NZ) Ltd | Freephone: 0508 367 366 | 5 Hewlett Street, Port Whangarei 0110 | vodaplumbingware.co.nz
Congratulations on your purchase of this high quality product from Voda Plumbingware.
Please read the following before installation and retain (along with your receipt) for future reference.
TECHNICAL SPECIFICATIONS
Suitable for All Pressures
Minimum Pressure = 35kPa
Maximum operating Pressure = 500kPa*
Maximum operating Temperature = 65 deg. Celsius
For domestic use only.
CONFIGURATION
Mains Pressure systems Install the flow regulator as shown in the diagram below.
Unequal Low systems Install as supplied.
Equal Low systems Install as supplied.
CONTENTS
• Rail with adjuster/holder
• Wall brackets
• Fixing kit
• 1.5m shower hose
• Supply elbow
• Shower handpiece
• Flow Regulator for Mains Pressure installation
INSTALLATION
*FOR PRESSURES EXCEEDING 500kPa INSTALL A PRESSURE REDUCING VALVE. THOROUGHLY FLUSH ALL
PIPES TO ELIMINATE ANY REMAINING DIRT AND RESIDUE, AND INSTALL INLINE FILTERS. FAILURE TO DO SO
MAY VOID THE WARRANTY.
8.0L/min Flow Regulator
Black O-ring Water Flow
Shower Elbow
(O-ring side)
Flow Regulator
Washer
Flexi Hose

The shower rail is adjustable, however the distance between holes
should be no more than 728mm apart.
Ensure main water supply is o before beginning installation.
• Measure, mark and drill holes for wall brackets. (1)
• Insert the wall plugs into drilled holes. (2)
• Unscrew the grub screw (6) on each wall bracket (5) retaining the brass wall fitting (3). Screw the wall fittings
onto the wall using the screws provided (4).
• Adjust the brackets on the rail to match the wall fittings. To adjust, unscrew the grub screws inside the top and
bottom brackets, then slide the top and bottom bracket up or down to match the spacing of the wall fittings.
Retighten the grubscrew inside the bracket. Fit the bracket onto the wall fittings then re-tighten the grub
screws (6) on the top and bottom brackets.
• Attach the wall plate (7) to the supply elbow (8) and screw onto the spigot on the wall (9).
• Attach supply hose to supply elbow.
• Attach conical end of the supply hose to the shower handpiece.
• Turn on water supply.
• Check for leaks.
WARRANTY
PLEASE CALL US BEFORE REMOVING TAPWARE OR UNDERTAKING ANY REPAIR WORK.
Please refer to our website for warranty information: www.vodaplumbingware.co.nz/warranty
In the unlikely event that this product fails during its warranty period, phone our Customer Service team
immediately on 0508 367 366 – as unauthorised removal of the product may void the warranty.
CARE AND MAINTENANCE
SHOULD NOT BE CLEANED WITH ASTRINGENT, ABRASIVE OR CITRIC CLEANERS.
A so, damp cloth is recommended for cleaning (Not a Micro fibre cloth). Mild soap solutions can also be used on
occasion.
ATTACH PROOF OF PURCHASE HERE
Voda Plumbingware (NZ) Ltd | Freephone: 0508 367 366 | 5 Hewlett Street, Port Whangarei 0110 | vodaplumbingware.co.nz
Max. 728 mm
1
1
2
2
3
3
4
4
6
5
7
9
8
5
6