Section 2 : Utilization
OPERATOR’S MANUAL
6
UTILIZATION
1a
1
2
3a
3
4
4a
6
7
1. -
pare the machine to operate and subsequently the tank temperature is displayed on the digital display (2).
Light indicates that the machine is powered up.
When lit the LED indicates that the machine is supplied with electricity.
Displays the functions and data set.
3. Time dispensing button. The factory set value is
7 corresponding to about 1 oz. By pushing the button “7”, after P1 parameter, it is possible to set a value
between 1 and 90 for the automatic dispensing of the whipped cream. The setting of value 1 corresponds to
a 0,5 sec. dispensing, up to a maximum value of 90, which corresponds to a 45 sec. dispensing. When the
button is active, its signal led (3a) is on.
Time dispensing button. The factory set value is
21 corresponding to about 3 oz. By pushing the button “7”, after P2 parameter, it is possible to set a value
between 1 and 90 for the automatic dispensing of the whipped cream. The setting of value 1 corresponds to
a 0,5 sec. dispensing, up to a maximum value of 90, which corresponds to a 45 sec. dispensing. When the
button is active, its signal led (4a) is on.
5. Button for the dispensing of the whipped cream:
- Manual, if the “PU” parameter has been set in “P3” programming. The dispensing will go on until the
“P3 Dispensing” button is released.
- Continuous, if the “CO” parameter has been set in “P3” programming. The dispensing will go on up to
the following pressing of the “P3 Dispensing” button. When the button is active, its signal led (5a) is on.
6. This button is active only during the programming
functions, its pushing allows the decrease of the selected value.
Dual function button:
a) the adjustment parameters (P1, P2, P3) as well as the corresponding set values are viewed in
sequence on the digital display by pressing the button for some seconds;
b) in the programming function the set value can be increased by pressing the button.
5
5a
