01 Quick guide
Quick start
01
8
Keypad/Remote control
•Use the navigation button - the keypad's
locating pin or the remote control's arrow
keys - to navigate up, down, right or left
between different menu options and selec-
tions, as well as to move the cursor on the
map.
•ENTER – Confirms or activates selections.
•BACK - Back in the menu structure or to
cancel a selection.
The keypad is located on the right-hand rear
side of the steering wheel, see page 20.
The buttons on the remote control have the
same functions as the keypad on the steering
wheel.
Activating the system
The remote control key must be inserted into
the ignition switch (see the owner's manual for
the car).
1. Briefly press the START/STOP ENGINE
button.
2. If the display is not activated: Press
BACK or ENTER.
Starting the system
The system starts by displaying a screen where
the text content has to be confirmed by press-
ing ENTER.
The system may then need a few seconds to
determine the position of the car. Map mode is
then displayed in which the position of the car
is shown with a blue triangle.
Guidance to street address
Set destina-
tion
Press BACK to access the
Main menu. Scroll with the
navigation button to Set
destination and press
ENTER.
Address Scroll to Address and
press ENTER.
Country/
City
Scroll to Country and City
respectively and press
ENTER. Scroll to the
required letters in order to
set the country and city in
which the street address is
located. Press ENTER.
Street Scroll to Street and press
ENTER.
Street num-
ber
Scroll to No. and press
ENTER.
Set Scroll to Set and press
ENTER.
Start guid-
ance
Scroll to Start guidance
and press ENTER.
The system now calculates the route and the
distance to the input destination. You receive
guidance and instructions on junctions etc.
If there is a deviation from the planned route
outline during the journey then the system
automatically calculates a new route outline.
Guidance to facility
Set destina-
tion
Press BACK to access the
Main menu. Scroll with the
navigation button to Set
destination and press
ENTER.
Facility Scroll to Facility and press
ENTER.
Facility by
name
Select Facility by name
and press ENTER.
P3; 4; 3 2008-03-20T13:01:05+01:00; Page 8
siggejohansson